MOROSO 68464 Fabricated Aluminum Valve Covers Instructions

June 4, 2024
MOROSO

MOROSO 68464 Fabricated Aluminum Valve Covers

MOROSO-68464-Fabricated-Aluminum-Valve-Covers

FABRICATED VALVE COVER INSTRUCTIONS

Gasket Rail notches should be checked against your particular head prior to running the engine. These notches may be modified easily with a die grinder.

  • Clean the gasket surface of both the cylinder head and the valve cover rail. Many petroleum cleaning products, leave a residue that can prevent a good seal.
  • If you are going to install positive locking breathers or fittings::
  • First protect the top of the valve covers by placing a protective material on your work surface.

Note you will be working inside the valve cover so the top will be against your table.

  1. Decide where the accessory will be attached. Mark the center of the hole with a center punch.
  2. Use a hole saw (the size will be called out in the instructions of the product you are attaching to your valve cover) next use a round file to clean the edges of and if needed, enlarge the hole slightly.
  3. To install grommets cut a 1-3/16IN. hole through the valve cover. Then use a round file to open the
    hole to approximately 1.22IN.

NOTE: Grommets for fabricated valve covers have a .090IN. groove a standard valve cover grommet will not only be a loose fit causing leaks but has a tendency to fall out (with your breather).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals