Klima C16 WiFi Floor Heating Thermostat User Guide
- June 12, 2024
- klima
Table of Contents
C16 Guide For programming the Controller
The C16 will follow the Schedule below as this is the default parameters.
C16 WiFi Floor Heating Thermostat
SECTION 1
- WAKE (PERIOD 1 START TIME): when it will switch on in the morning and what temperature it will heat up to
- LEAVE (PERIOD 1 END TIME): When it will turn off and what temperature it maintains at, (We recommend for it to stay a temperature that is 5 degrees lower than the temperature set for when it is heating)
- BACK (PERIOD 2 START TIME): When it will turn back on for the afternoon
- SLEEP (PERIOD 2 END TIME): When it will turn off (We recommend for it to stay a temperature that is 5 degrees lower than the temperature set for when it is heating)
Day| | | |
---|---|---|---|---
Mon-Fri| 12:06 20.0 ºC| 08:30 15.0 ºC| 17:00 20.0 ºC| 23:00 15.0 ºC
Sat/Sun| 12:06 20.0 ºC| 08:30 20.0 ºC| 17:00 20.0 ºC| 23:00 15.0 ºC
If you want to set it so you can set Each day individually then please follow
Steps A1
If you want to set it so you can program Monday Friday as one time and then
Saturday and Sunday as different day, please follow Steps B1.
A STEPS
A1) Press and Hold the square Button for three seconds (this should appear)
A2) Press the Up arrow until in the
top right it says `SER’
A3) Press the Square Button ONCE
A4) Press the square Button until it says “5” in the top left
A5) Make Sure in the top right it says “00” then press the square button until
you’re at the home screen.
B STEPS
B1) Follow steps A1 A4
B2) Press the up button ONCE, in the top right it will say ’01’
B3) Press the square button until you’re at the home screen.
C STEPS - > PROGRAMMING OF CONTROLLER UNIT
BEFORE STARTING THIS PROGRAMMING SECION PLEASE REVIEW THE TOP SECTION WHICH
ATTACHED IS THE SCHEDULE. WHEN PROGRAMMING THE SCHEDULE WILL FOLLOW THE
PATTERN DISPLAYED IN SECTION 1(AT BEGINNING OF GUIDE)
C1) Press and HOLD the square button for three seconds
C2) Press the Up arrow until in the top right it says “EVE”
C3) Press the square button ONCE
C4) Press the up arrow to select the day of the week you want to program
C5) When on the day you want to program press the square button ONCE
C6) The first screen will show a House type symbol (please look at schedule in
SECTION1, the symbols shown represent the different time periods) in the
bottom left-hand corner as an example can be seen below
C7) With following the schedule at
the top choose the relevant period you want to change by pressing the UP or
DOWN arrow
C8) Press the Square Button Once
C9) Press the Up arrow or Down arrow until you select the desired hour then
press the square button ONCE
C10) Press the Up or Down arrow until you select it to the correct Minutes and
then press the square button ONCE
C11) Press the Up or Down arrow until you select the temperature you want to
heat it up to
C12) Repeat steps C7 C11 for the rest of the different periods and this will
follow the schedule shown in SECTION 1
C13) When you have completed setting the times, then press the UP arrow until
END is highlighted and flashing and press the square button ONCE.
C14) This will now implement and will follow the programmed times
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>