BRAVO 80027.01 High Pressure 12 Volt Pump User Manual
- June 12, 2024
- BRAVO
Table of Contents
80027.01 High Pressure 12 Volt Pump
User Manual
B TP12MANOMETER-ELECTRICAL INFLATOR 12V DC
READ THE INSTRUCTIONS CAREFULLY BEFORE USE
Dear Customer, Thank you for choosing the BTP 12 inflator manometer. This
device has been designed specifically to inflate/deflate dinghies up to 5/6
meters and all kites on the market.
FEATURES
- Power supply 12V DC
- Maximum absorption 20 A
- Maximum pressure 1 bar / 14.5 psi
- Maximum flow rate Turbine 450 l/min – Piston 160 l/min
- Weight 1.7 Kg
- Dimensions 290x100x150 mm
WARNINGS
- Before connecting the terminals to the battery, check that the voltage is the same as shown on the label.
- Keep the product out of the reach of children. Do not leave the inflator running unattended.
- Do not use the inflator with adapters other than those supplied with the product as they could damage the device.
- Repairs must only be undertaken by an authorized customer technical service Scoria Spa.
- The manufacturer is not responsible for damage caused as a result of improper use or failure to observe the envisaged usage.
Long periods of use can cause overheating and damage the product. Do not use for more than 20 minutes continuously.
INFLATION OPERATION
- From the supplied fittings, select the reducer that engages and opens the valve of the inflatable structure.
- Insert the selected adaptor on the braided joint on the end of the tube.
- Turn the ring nut on the manometer and point the arrow to the required pressure.
- Tighten the adaptor onto the inflation side of the inflator (OUT).
- Connect the terminals paying attention to the polarity and press the (ON) button to start inflation.
- The inflator operates in two stages which can be identified by the noise of the turbine at the beginning followed by the piston. The inflator switches from turbine to piston automatically.
- Once the entered pressure has been reached, the inflator turns off automatically. It is possible to stop the inflator at any time by pressing the OFF switch.
ATTENTION: When the device is under pressure, never turn the ring nut on the manometer anti-clockwise as this would immediately cause the instrument to break. Protect the inflator from sand by keeping it in the bag provided: if sand gets into the inflator, it could get JAMMED.
DEFLATING OPERATION
- As above.
- Tighten the adaptor on to the deflation side of the inflator (IN).
- Connect the terminals and press the (ON) button to start deflation.
- THE INFLATOR DOES NOT TURN OFF AUTOMATICALLY!!!
When the inflatable is completely deflated, press the OFF button immediately to avoid overheating the motor.
SAND FILTER MAINTENANCE
The inflator has a filter compartment under the inflation chuck (IN).
We recommend to keep them clean for the inflator to be longer lasting and more
effective.
- Loosen the two screws blocking the inflation chuck (IN).
- Lift the chuck and take it off.
- Clean with compressed air or replace if it is too dirty.
WARRANTY
The inflator is guaranteed for 2 years. In case of claims do not touch the
device and send it free-destination to Scoria Spa. or directly to the seller.
BATTERY
A battery kit is available comprising a Ni-Mh battery and battery charger. It
can be requested from the retailer
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>