unitech EA520 Vehicle Cradle User Guide

June 12, 2024
unitech

EA520 Vehicle Cradle
User Guide 609574G V1.0

Product View

unitech EA520 Vehicle Cradle - Product View

  Install EA520 into the Vehicle Cradle

Insert EA520 from top to bottom until it reach the bottom

unitech EA520 Vehicle Cradle - Vehicle

 Package

Please make sure the following contents are in the EA520 vehicle cradle gift box.
If something is missing or damaged, please contact your Unitech representative.

  The Package Contents

  • EA520 Vehicle Cradle
  • USB Type-C Cable (power input: 5V/2A)
    *Note: The package does not include USB car charger
    (cigarette charger). Please apply the car charger with
    power output 5V/2A to match with EA520 vehicle cradle.

  Optional Accessories

  • Attached Cover (for EA520 without boot case)
  •  HD AMPs Bracket with 26mm Ball Joint Part (with AMPs screws)
  • Dashboard Mount Only
  • HD AMPs Mount

How to use the Vehicle Cradle

Insert EA520 with boot case into the vehicle cradle directly.

  • It is suggested to charge EA520 without boot case after putting the attached cover into the vehicle cradle to prevent noise while shaking. The attached cover is optional for securing EA520 without the boot case more firmly.

Insert the Attached Cover into the Cradle

Put the attached cover into the cradle and make sure the arrows of the attached cover are pointing upward and match with the cradle.unitech EA520
Vehicle Cradle - the Cradle

Remap the Volume Key

The power key is not accessible while EA520 is in the vehicle cradle, so it’s suggest to “remapping” the volume key to wake up the screen. Please follow the directions below to remap the volume key to wake up screen.

  1. Enter Stage Go from the Apps.

  2. Scan the barcode on the right .

    **002B7iVMJ1ycvuz1HfV1xgbKyoYccc2r1Lt0000100,EA520,,dm9sdW1lKw==,0xbGvEy2XxHiY42NNwbCkGsl2CqsTBhOU2FGqcD0mDI=**

Note: This barcode is designated to be scanned by Stage Go. Scanning through USS is not effective.

  1. The screen will show as below.
    The number of success is “1”, meaning you have successfully finish key remap setting.

unitech EA520 Vehicle Cradle - setting

Charging through Vehicle Cradle

Connect one end of the USB Type-C cable to the USB port on EA520 vehicle cradle, and the other end to USB car charger (cigarette charger).

 Go back to Original Setting

  1. Click on Key Remap in the Apps.
  2. Click on VOLUME_UP.
  3. Select Action, then select Default key: VOLUME_UP.unitech EA520 Vehicle Cradle - VOLUME UP 2

CAUTION!

  • To ensure the unit working properly, please keep all connectors away from the contaminants staying inside of them such as dust, grease, mud, and water.
    The negligence may cause the unit with no communication, short circuited, overheated and so on.

  • If the connector is damaged, please ensure the connector is being fully repaired before using the unit to avoid causing short circuited.

http://www.ute.com/
Copyright 2022 Unitech Electronics Co., Ltd. All rights reserved.
Unitech is a registered trademark of Unitech Electronics Co., Ltd.

Documents / Resources

| unitech EA520 Vehicle Cradle [pdf] User Guide
EA520 Vehicle Cradle, EA520, Vehicle Cradle, Cradle
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals