ARBOR SCIENTIFIC P2-7150 Mega Mirrors Installation Guide
- June 12, 2024
- ARBOR SCIENTIFIC
Table of Contents
Mega Mirrors
P2-7150, P2-7150-01, P2-7150-02
ASSEMBLY GUIDE
Contents
Pair of Mega Mirrors
Convex and Concave Mirrors
Convex and Concave Mounting Brackets
2 Sets of Mounting Hardware
2 Allen Keys
2 Mounting Rods
Recommended, not included:
2 Ring Stands (66-4220)
2 Swivel Clamps|
Convex Mega Mirror
Convex Mirror
Convex Mounting Bracket
Set of Mounting Hardware
Allen Key
Mounting Rod
Recommended, not included:
Ring Stand
Swivel Clamp|
Concave Mega Mirror
Concave Mirror
Concave Mounting Bracket
Set of Mounting Hardware
Allen Key
Mounting Rod
Recommended, not included:
Ring Stand
Swivel Clamp
---|---|---
Assembly
-
Lay the mirror face-down on a flat surface. Use a soft towel under the convex mirror to prevent scratching.
-
Carefully align the mounting bracket over the mounting holes. The concave mirror uses the U-shaped bracket, and the straight bracket is for the convex mirror.
-
Insert a screw through the front of the mirror and fasten with a black plastic cap nut as shown. Repeat for the other hole.
-
With the included allen key, hold the plastic nut and tighten the screw. Do not over-tighten! The mirrors are not heavy and only need to be snug.
-
With the mirror still on its face, thread the mounting rod into the tapped hole in the center of the bracket.
-
Set the mirror aside and assemble the ring stand by fastening the rod into the iron base.
-
If using a swivel clamp and ring stand, fasten the clamp near the top of the ring stand. For ease of use, make sure the part of the clamp with the set screw can remain stationary.
-
Finally, mount the mirror to the ring stand as shown. Be sure the clamp grasps the mounting rod close to the bracket. This allows for more stability and ease of adjustment.
Note: To adjust the angle of the mirror, first loosen the set screw. Then, move the mirror into place and re-tighten the set screw.
800-367-6695
www.arborsci.com
©2022 Arbor Scientific All Rights Reserved
References
- Physics and Chemistry Science Lab Equipment – Arbor Scientific
- Physics and Chemistry Science Lab Equipment – Arbor Scientific
- Ring Stand, 5" x 8" Base, 20" Rod - Arbor Scientific
- Swivel Clamp Holder - Arbor Scientific
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>