LookOurWay 5ft Feather Flag and Pole Set Instructions
- June 12, 2024
- LookOurWay
Table of Contents
LookOurWay 5ft Feather Flag and Pole Set
5ft Feather Flag & Pole Set Instructions
STEP 1
Check to make sure all parts in the first diagram are included. Insert pole #1
(the fiberglass piece) into pole #2, and finally insert both into pole #3.
STEP 2
Slide the end of the pole #1 into the sleeve of the feather flag. Slide the
feather flag down until the pole has reached the end of the sleeve.
STEP 3
Find the black loop of the feather flag. Hook this onto the loop holder piece
on pole #3. Slide the feather flag loop holder down the shaft of the pole
until the feather flag achieves a good clean shape. Tighten down the loop
holder by turning the knob clockwise.
STEP 4
If using a ground spike, first stick the spike into the ground by hammering
the solid top of the spike (not the pole set receptacle hole), until secured
into the ground. Then continue to step #6 below.
STEP 5
If using an X-Stand, place the shorter leg down, place the washer over the
hole,place the longer leg on top. Insert the threaded bolt up through the
bottom of the legs, screw dowel into the threaded bolt firmly but do not over
tighten.
- 4. Dowel – X-Stand
- 5. Bolt – X-Stand
- 6. Washer – X-Stand
- 7. X-Stand Leg – Tall
- 8. X-Stand Leg – Short
STEP 6
Insert the end of the fully assembled feather flag pole into the receptacle of
the chosen base unit.
Fiberglass Pole Set Assembly Instructions
Step 1: Place all parts on a clean flat surface
Step 2: Connect all poles by inserting them into each other, starting
from the top.
(Pole 5 -> Pole 4 -> Pole 3 -» Pole 2 ->
Pole 1 -> Base. Note: NO POLE 2 for 8ft
Step 3: Carefully insert the top end of the assembled poles into the pole
pocket on flag.
Push the pole through as far as it will go until it hits the end. DO NOT
FORCEFULLY PUSH THE POLE OR IT COULD SNAP.
Step 4: Locate the pole hook located on the bottom pole. Raise the Hook until you can attach the loop at the bottom of the flag. Apply firm tension and tighten hook in place.
Note: Keep product clear from trees, poles, buildings or any other obstruction as it will cause premature wear.
Optional Bases & Accessories
Optional Ground Spike
Hammer the Spike Base into the ground at desired location & install the flag
onto rotating mount MAKE SURE YOU HAMMER
THE BLUNT END OF THE SPIKE AND NOT THE ROTATING FLAG MOUNTING POINT
NOTE: This is an optional product
Optional X-Stand
Assemble the X-Stand by corssing both legs and securing assembly by screwing
the weighted dowel into the center. Instal flag poleover the top.
Optional Water Bag
Place the water bag over the base BEFORE attaching the flag pole. Fill bag
with water for stability
NOTE: This is an optional product
Optional Carrying Case
We highly recommend using our optional Premium Carrying Case for storage &
Transportation of your flags.
NOTE: This is an optional product
Store all items in a cool dry location away from direct sunlight.
To Clean, wipe with damp cloth. Do not iron or dry clean the flags.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>