SUNCO 6 Inch Slim Selectable White Led Light Instruction Manual
- June 12, 2024
- SUNCO
Table of Contents
6” SLIM SELECTABLE
WHITE LED LIGHT
Install Guide and Manual
The Brighter Choice
Required Tools: Ladder, Drywall Saw, Wire Strippers.
COMPONENTS
IC Rated Junction Box
-
Turn off circuit breaker that provides power to the light switch for the recessed lights.
-
Cut a hole in the ceiling in the desired location accordingly to the dimension indicated.
-
Run electrical wire from the power source (switch) through the mounting hole.
-
Open the junction box and remove the appropriate knockout(s) on the side plate.
-
Connect the supply wires to the junction box wires using the wire nuts provided.
• White to white
• Black to black -
Tuck the connected wires inside the junction box and close the cover.
-
Connect the junction box to the slim down light. Tighten the connector by hand.
-
Turn on power and test light.
-
BEFORE PROCEEDING:
On back of j-box, slide the CCT Selection Switch to choose from five color temperatures (2700K, 3000K, 3500K, 4000K, 5000K). Try each CCT to determine which suits your room.
• Light will use the preferred setting whenever you turn on switch.
• Turn off light switch and continue install.
-
Insert junction box through the hole in the ceiling.
• New construction applications: Hardwire box shall be secured to studs, joists, or similar fixed structural units.
• Remodel applications: Do not require the hardwire box to be firmly secured after the mounting plates studs, joists, or structural units have been concealed.
-
Push up the spring clips to insert the luminaire in the opening in the ceiling.
-
Turn on circuit breaker and test the light.
WARNING
To reduce the risk of fire, electric shock or injury to people:
- This product should be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
- Abide by related regional and local laws or regulations.
- Do not alter, relocate or remove wiring.
- Do not make or alter any open holes in enclosure or electrical components.
- Proper grounding is required to ensure safety.
- Check for damage during shipping prior to install. If the product is damaged, do not use it.
- Turn off the switch and circuit breaker before installing this LED light.
- Use safety precautions. Safety eyeglasses and gloves are recommended.
- Please review instructions carefully before proceeding.
SPECIFICATIONS
| Voltage | Indoor |
|---|---|
| Wattage | Plastic |
| Usage | 0.6 lbs |
| Housing | 7 years |
| Weight | 120V |
| Warranty | 14W |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>