MARVOWARE AF1114 2 Inch Hitch Bike Rack for Cars Instruction Manual

Table of Contents

Manual

Foldable Platform Style Bicycles Carrier

Model number. AF1114

Foldable Platform Style Bicycles Carrier

Step 2-3

Step 4

Please read and observe the instructions carefully before you use the product, and keep them in a safe place for future use. Check the part list after opening the package. Make sure that all the parts are fully assembled according to the instruction before fitting it on your car.
The user is responsible for assembly and installation of this product, and the manufacturer disclaims any liability due to improper fitting or use of the product.
Failure to properly install this bike carrier and/or the bikes may cause damage to the vehicle and/or the bikes, and may result in personal injury.
Do not use this product for purposes other than those for which it is designed. Do not modify any components of the product. Remove the carrier if not in use.
Do not use the carrier to carry more bikes than recommended. The weight of each bike cannot exceed 66lbs.
The bike carrier designed to be fitted directly on the vechicle which have the hitch with 2 inch size.
This bike rack is not intended for transporting tandem, or recumbent bicycles.
Do not transport bicycles with attached baby seats, panniers, wheel covers, full bike covers or motors.

Please make sure you clean the surface of the hitch receiver completely before installing the rack.
Always use the safety strap to attach the bikes to the bike carrier.
Check if the distance from the exhaust pipe to the bicycle tires is safe for your bicycles or the straps of the carrier.
The heat of the exhaust could damage the bike or bicycle racks.
If your vehicle is equipped with an automatic tailgate opening system, disable this function when using the bike carrier, and open the tailgate manually.
When loading the bicycles, remove all loose parts and accessories from bicycles (toolbars, baby carriers, pumps, etc.)
Always position the biggest/heaviest bike first and closest to the car, and then position the smaller bike after that.
The user is responsible for periodically verifying that all hardware, straps, knobs, hubs are securely tightened for safety purposes.
You might have to use extra protections to protect the bikes and the tailgate from scratches.
Do not open the gate with the bikes installed on the carrier.

Check before departure that the light board of the carrier is properly functioning.
The bicycle rack increases the vehicle’s length, and the bicycles may increase its width and height. Be aware of this when passing through narrow or low clearance spaces and when reversing. Any loads exceeding the indicated dimensions must nevertheless respect existing regulations and be properly strapped down.
The load of rack and bicycles will affect driving. Do not exceed the speed limit, and do not drive faster than 120 km/h (75 mph).
Drive slowly over speed bumps. Respect the speed limit, and adapt your speed to the condition of the road.
Off-road driving is not recommended and could result in damage to your vehicle, hitch receiver, bike carrier, or your bikes.
If you hit a bump or a hole in the road, stop your vehicle and inspect the bikes and the carrier. If you notice anything wrong, remove the bikes and do not use the bike carrier.
Make sure there is a safe distance between the bikes and the ground, especially when entering a driveway

Periodically inspect the product for signs of wear, corrosion, and fatigue.
Do not use the carrier with defective parts, contact the dealer to replace them before using it again.
Remove the product before entering an automatic car wash.
To keep your product in the best condition, it is recommended to remove the product from the car when not in use.
Please be advised that this product is not designed to resist extreme weather conditions, especially seacoast air.
Lubricate the bolts in order to avoid corrosion.

Read User Manual Online (PDF format)