Simplicity VACUUMS Scout Canister Vacuum Owner’s Manual

October 30, 2023
Simplicity VACUUMS

**Simplicity VACUUMS Scout Canister Vacuum Owner’s Manual

**

IMPORTANT SAFETY INSTRUCTIONS

READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE USING THIS UNIT.
This vacuum must be operated in accordance with these instructions and used only for domestic household cleaning to remove DRY dirt and dust from household carpets, flooring, walls, and fabrics. This cleaner is not fit to be used as an industrial cleaner and will void the manufacturer’s warranty if used inappropriately. Please read these instructions thoroughly. This will ensure you obtain full benefit from your new vacuum. Keep this Owner’s Manual in a convenient and safe place for future reference.

IMPORTANT:
The manufacturer cannot accept responsibility for damage caused when the appliance is not used according to the instructions, or for uses other than those for which it was intended

WARNING: To reduce the risk of fire, electric shock, damage or injury:

  • Empty the bag when the full bag indicator turns red. Over-filling the bag may cause dirt and debris to clog the vacuum and cause loss of suction.
  • Always unplug the vacuum from the electrical outlet before replacing the bag or filters.
  • Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing.
  • WARNING: ELECTRIC SHOCK COULD OCCUR IF USED OUTDOORS OR ON WET SURFACES.
  • Do not allow to be used as a toy. Close attention is necessary when used by or near children.
  • Use only as described in this manual. Use only manufacturer’s recommended attachments.
  • Do not use with damaged cord or plug. Or if appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to your Authorized Simplicity Retailer for service.
  • Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
  • Do not handle plug or appliance with wet hands.
  • Do not pull or carry by cord, use cord as a handle, close a door on the cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
  • Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair and anything that may reduce air flow.
  • Keep hair, loose clothing, fingers and all parts of body away from openings and moving parts.
  • Do not pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes.
  • Do not use without bag or filters in place.
  • Turn off all controls before unplugging.
  • Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present.
  • Do not attempt to service the unit while appliance is plugged in.
  • Do not use vacuum to pick up water or any wet materials.
  • Use extra care when cleaning on stairs
  • Always turn off and unplug vacuum cleaner before connecting or disconnecting either hose, wand or floor tool.
  • Hold plug when rewinding cord reel. Do not allow plug to whip when rewinding.

SAVE THESE INSTRUCTIONS

Power Cord, 2-Wire Polarized Cord
To reduce the risk of electric shock, the vacuum is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact a qualified electrician to replace the obsolete outlet. Do not defeat the safety purpose of the polarized plug.
Wire Polarized Cord

PARTS IDENTIFICATION

Parts Identification

  1. Handle
  2. Suction air flow adjuster (on handle)
  3. Telescopic Wand
  4. Dust Bag Cover Latch
  5. Air Inlet
  6. Accessory Cover Release Button
  7. Full Dust Bag Indicator
  8. Standby On/Off Button
  9. Exhaust Filter Release Button Nozzle
  10. Cord Rewind Button
  11. 3-in-1 Cleaning Tool
  12. Combination Floor Tool

IMPORTANT! Always remove the power cord from the power supply before fitting or removing accessories!

Flexible Hose

  • Fitting: Insert the flexible hose into the air inlet of the vacuum. Press until it clicks into position. (Fig 1)
  • Removing: Press the two buttons and gently pull to release the flexible hose. (Fig 1)
    Flexible Hose

Handle

  • Gently insert the handle into the telescopic wand. (Fig 2)
    Handle

  • Place the floor tool onto the floor and gently insert the wand into tool.
    Handle

ACCESSORIES

Combination Floor Tool
This multi-purpose combination floor tool easily switches from a carpet cleaning tool to a hard floor tool. (Fig 4)
Accessories

3-in-1 Cleaning Tool
Combines a crevice tool, upholstery tool & dusting brush all in the one tool for convenient cleaning. To use the 3-in-1 Cleaning Tool as an upholstery tool oras a dusting brush simply remove the crevice tool and insert the crevice tool into the opposite end of the tool you would like to use. (Fig 5 )
Accessories

Upholstery Tool
For Vacuuming furniture and upholstery. (Fig 6)
Upholstery Tool

Crevice Tool
Eliminate dust from hard to reach places. (Fig 7)
Crevice Too

Dusting Brush
Ideal for cleaning blinds, bookshelves and lampshades. (Fig 8)
Dusting Brush

CONTROLS

The suction power can be regulated by using the Digital Power Control to achieve optimal cleaning results. To change the suction power to suit a particular cleaning task, press the Power Increase Button to increase the suction power, and to reduce the suction power, press the Power Decrease Button

The Dust Bag Indicator will continually flash red to indicate that the dust bag requires replacement or to indicate that there is a blockage. (Fig 9)
Controls

Note: In the two lowest settings, the dust bag indicator will not flash.

Using the Cord Rewind Button and Standby On/Off Button

Standby On/Off Button (Fig 10)
Using Instruction

  1. Unwind a sufficient length of power cord. The yellow mark on the power cord shows the recommended cord length. DO NOT extend the cord beyond the red mark.
  2. Insert the cord into the outlet.
  3. Press the Standby On/Off button to put the vacuum into Standby Mode.
  4. To switch On the cleaner:
    • Press the Power Decrease or Power Increase buttons on the Digital Power Control panel.

Rewind (Fig 11)
Using Instruction

  1. Press the On/Off button to switch off the vacuum.
  2. Unplug the cord from the power outlet.
  3. To rewind the power cord, press the rewind button with one hand and guide the cord with the other hand to ensure that the power cord does not whip.

Note: Do not unplug by pulling on the power cord. To unplug, grasp the power plug not the power cord and gently pull the power plug from the power outlet

Vacuum Cleaner Storage
When not in use, ensure that the cleaner is disconnected from the power supply and that the cable is fully retracted. The combination floor tool can be stored in the floor tool holders. Other floor tools must be stored separately.

MAINTENANCE

Replacing the Dust Bag
IMPORTANT! Ensure that the cleaner is disconnected from the power supply when installing or removing the dust bag.

Note: Only use the dust bag supplied or recommend by the manufacturer to avoid causing damage to the machine and voiding the warranty.
(Fig 12)
Using Instruction

Always operate the cleaner with the dust bag installed. If you forget to install the dust bag or the dust bag is installed incorrectly, the dust bag cover may not close completely.

  • Remove the hose from the air inlet.

  • Open the cover by pulling on the Dust Bag Cover Latch.

  • To stop dust and debris from escaping when removing the dust bag from the machine, firmly hold the dust bag in the dust bag holder and gently pull the dust bag seal.

  • Refit a new dust bag by inserting the dust bag collar into the dust bag bracket. Ensure that the arrow on the dust bag collar is facing downwards when being inserted into the dust bag bracket.
    Note: The dust bag has been designed with a seal to prevent dust and debris from escaping when the dust bag is removed from the cleaner.

  • Gently close the cover, you will hear a ‘click’ when closed properly.

Note: Please ensure that the dust bag is fully inserted into the dust bag bracket before closing the cover to avoid dust leaking from the dust bag.

Pre-Motor Filter Replacement
IMPORTANT! Ensure the cleaner is disconnected from the power supply before performing any maintenance procedures.

The pre-motor filter should be replaced every six months or when it becomes visibly dirty. Always operate the cleaner with clean filters; otherwise, there may be a reduction in the suction power or motor damage may result.

Note: Do not use a washing machine to wash the filter or a hair drier to dry the filter

  • Pull out the filter bracket assembly.
  • Replace with a new filter. (Fig 13)
    Using Instruction

Exhaust HEPA Type
Filter Replacement
IMPORTANT! Ensure that the cleaner is disconnected from the power supply before performing any maintenance procedures.

The Exhaust HEPA Type filter is installed behind the air outlet grill. This filter is washable. When dust or dirt is visible on the surface of the filter, the filter should be replaced or washed with warmwater to maintain optimal performance. It is recommended to replace the filter every 6 months or when it becomes visibly dirty. This may vary depending on frequency of use. Please ensure all filters have been correctly installed into the machine before use.
Using Instruction

  • Press the Exhaust Filter Release Button to access the Exhaust HEPA type filter. (Fig 14)
  • Remove the filter by pulling on the filter tabs as shown. (Fig 15)
    Using Instruction
Problem Check Point Possible Solution
The vacuum does not power Power cord Insert the power plug firmly into an

electrical outlet
Suction power is weak.| Bag Blocked hose or wand| Replace if the bag is full. Remove obstruction.
Vacuum makes an abnormal sound when on.| Brush roller Blocked hose| Turn off immediately. Check to ensure there are no blockages. Clear any blockages that may be found. Check that tool is installed securely
Any other service should be performed by an Authorized Simplicity Vacuum Retailer. To locate your nearest Authorized Retailer, visit our website at www.SimplicityVac.com or call 888-974-6759.

FOR BEST PERFORMANCE

  • Use machine with a bag, pre-motor filter, and pleated filter.
  • Keep machine and all accessories clean and in good operating condition.
  • Replace bag when it’s 2/3 full. The replacement bag number is SSH-6.
  • Check and replace filters every 6 months or more frequently if vacuuming fine powders such as flour or drywall dust.
  • Always use genuine filters and parts, as use of other products may result in poor cleaning or filtration performance. Genuine Simplicity filtration products are designed for maximum performance.
  • Store machine in a clean, dry area indoors.
  • For optimum cleaning performance and safety, follow this owner’s manual

WARRANTY INFORMATION

What is Covered:
This warranty covers any defects in material and workmanship in your new Simplicity vacuum.

How Long Coverage Lasts:
Warranty coverage for this Simplicity vacuum lasts one year. Household models used commercially are only warranted for 90 days
Simplicity

What’s the best way to be a part of the in crowd?
It’s simple: register your Simplicity vacuum today and activate your warranty.
How do you like your vacuum?
Once you’ve had some time to try out your new Simplicity vacuum, we want to know what you think — leave a product review. It only takes a few minutes and it helps us make our products better… and your home simply cleaner.

Costumer Support

888-974-6759
1760 Gilsinn Lane
Fenton, MO 63026
Simplicity Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals