hansgrohe 31070000 Metris E Single Lever Basin Mixer Chrome Instruction Manual
- October 30, 2023
- hansgrohe
Table of Contents
hansgrohe 31070000 Metris E Single Lever Basin Mixer Chrome
Product Information
The product is a shower system with a single-lever mixer that has a warm water limiter. It has a maximum operating pressure of 1 MPa and a recommended operating pressure of 1.6 MPa. The hot and cold supplies must have equal pressures. The product comes with spare parts and a flow diagram, and it can be used with hydraulically and thermally controlled continuous flow heaters if the flow pressure is at least 0.15 MPa.
Product Usage Instructions
When installing the shower system, it is important to wear protective gloves to prevent crushing and cutting injuries. The system should only be used for bathing, hygienic, and body cleansing purposes. It is important to compensate for any differences in pressure between the hot and cold water supplies. To adjust the warm water limiter on the single-lever mixer, please refer to page 33. No adjustment is necessary when using a continuous-flow water heater. Do not use silicone-containing acetic acid when installing the product. Use the special tool (58085000) to assist in installation, which can be ordered separately. An installation kit can also be ordered separately. Cleaning instructions can be found in the enclosed brochure, and a test certificate is available on page 35. To assemble the product, please refer to page 31.
Safety Notes
- Gloves should be worn during installation to prevent crushing and cutting injuries.
- The shower system may only be used for bathing,
- hygienic and body cleansing purposes.
- The hot and cold supplies must be of equal pressure.
- Installation Instructions
- The fitting must be installed, flushed and tested after the valid norms.
- If the instantaneous water heater causes problems or
- if you wish to increase the water flow, the EcoSmart® (flow limiter) located behind the aerator can be removed.
Technical Data
This mixer series-produced with EcoSmart® (flow limiter)
- Operating pressure: max. 1 MPa
- Recommended operating pressure: 0,1 – 0,5 MPa
- Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI)
- Hot water temperature: max. 80°C
- Recommended hot water temp.: 65°C
Hansgrohe mixers can be used together with hydraulically and thermically controlled continuous flow heaters if the flow pressure is at least 0,15 MPa.
Assembly
Symbol Description
To adjust the hot water limiter on single lever mixers, please see page 33. No adjustmentis necessary when using a continuous flow water heater.
Do not use silicone containing acetic acid!
Dimensions (see page 34)
Flow diagram (see page 34)
-
* with EcoSmart®- without EcoSmart
-
Spare parts (see page 36)
-
Special accessories: special tool (58085000) ordered as an extra
-
Installation kit order as an extra
-
Operation (see page 35)
-
Cleaning (see enclosed brochure)
-
Test certificate (see page 35)
CONTACT
- Postfach 1145
- D-77761 Schiltach
- Telefon +49 (0) 78 36/51-1282
- Telefax +49 (0) 7836/511440
- E-Mail: info@hansgrohe.com.
- Internet: www.hansgrohe.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>