hansgrohe 13117000 Ecostat Comfort HQ Shower Mixer Instruction Manual
- October 30, 2023
- hansgrohe
Table of Contents
- hansgrohe 13117000 Ecostat Comfort HQ Shower Mixer
- Product Information
- Product Usage Instructions
- Safety Notes
- Installation Instructions
- Technical Data
- Symbol description
- ADJUSTMENT
- Safety Function (see page 33)
- Cleaning (see page 35)
- Maintenance (see page 35)
- Dimensions (see page 36)
- Flow diagram (see page 36)
- Spare parts (see page 37)
- Operation (see page 34)
- Test certificate (see page 32)
- ABOUT COMPANY
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
hansgrohe 13117000 Ecostat Comfort HQ Shower Mixer
Product Information
The product is ECOSTAT Comfort, available in two models: HQ 13112000 and 13114XXX, and ECOSTAT Comfort Care, available in two models: 13115000 and 13117000. The product provides bathing, hygienic and body cleaning purposes. However, it is not to be used as a holding handle. A separate handle must be installed. The product must not be used by children or adults with physical, mental and/or sensoric impairments without proper supervision. Persons under the influence of alcohol or drugs are prohibited from using this product. The hot and cold supplies must be of equal pressures.
Product Usage Instructions
During installation, gloves should be worn to prevent crushing and cutting injuries. ECOSTAT can be used in conjunction with flow heaters. The recommended operating pressure is 0.1 – 0.5 MPa, while the maximum operating pressure is 1 MPa. The test pressure is 1.6 MPa. The product comes with an adjustable thermostat for temperature control and a safety function to prevent scalding. The product needs to be cleaned and maintained regularly as per the instructions provided on pages 35 and 36 of the user manual. The product comes with a flow diagram on page 36 for easy understanding of the water flow. The product can be used for both shower and bathtub purposes as per the outlets provided.
Safety Notes
- Gloves should be worn during installation to prevent crushing and cutting injuries.
- The product may only be used for bathing, hygienic and body cleaning purposes.
- The product may not be used as a holding handle. A separate handle must be installed.
- Children as well as adults with physical, mental and/or sensoric impairments must not use this product without proper supervision. Persons under the influence of alcohol or drugs are prohibited from using this product.
- The hot and cold supplies must be of equal pressures.
Installation Instructions
-
Prior to installation, inspect the product for transport damages. After it has been installed, no transport or surface damage will be honoured.
-
The pipes and the fixture must be installed, flushed and tested as per the applicable standards.
-
The plumbing codes applicable in the respective countries must be observed.
-
The product is not designed to be used with steam baths!
ECOSTAT in conjunction with flow heaters -
If fitting a hand shower remove the water limiter from the shower.
-
If the continuous water heater causes any problems, or you have different water pressures you must install a water limiter to the cold supply, (ordered separate-ly,article number 97510000).
Technical Data
-
Operating pressure: max. 1 MPa
-
Recommended operating pressure: 0,1 – 0,5 MPa
-
Test pressure: 1,6 MPa
(1 MPa = 10 bar = 147 PSI) -
Hot water temperature: max. 70°C
-
Recommended hot water temp.: 65°C
-
Centre distance: 150±12 mm
-
Connections G 1/2: cold right – hot left
-
Thermal disinfection: max. 70°C / 4 min
-
Safety against backflow
-
The product is exclusively designed for drinking water!
Symbol description
After the installation, the output temperature of the thermostat must be checked. A correction is necessary if the temperature measured at the output differs from the temperature set on the thermostat.
ADJUSTMENT
Safety Function (see page 33)
The desired maximum temperature for example max. 42º C can be pre-set thanks to the safety function.
Cleaning (see page 35)
Maintenance (see page 35)
- The check valves must be checked regularly according to DIN EN 1717 in accordance with national or regional regulations (at least once a year).
- To guarantee the smooth running of the thermostat, it is necessary from time to time to turn the thermostat from total hot to total cold.)
Dimensions (see page 36)
Flow diagram (see page 36)
- Shower outlet
- Tub outlet
Spare parts (see page 37)
- XXX = Colors
- 000 = Chrome Plated
- 140 = Brushed Bronze
- 340 = Brushed Black Chrome
- 670 = Matt Black
- 700 = Matt White
- 800 = Stainless Steel Optic
- 990 = Gold Plated
Operation (see page 34)
Test certificate (see page 32)
ABOUT COMPANY
- Hansgrohe · Auestraße 5
- 9 · D-77761 Schiltach
- Telefon +49 (0) 78 36/51-1282
- Telefax +49 (0) 7836/511440
- E-Mail: info@hansgrohe.com
- Internet: www.hansgrohe.com
References
- Taps for bathrooms, showers and kitchens | hansgrohe INT
- Taps for bathrooms, showers and kitchens | hansgrohe INT
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>