ZAMP SOLAR KIT1019 25W Obsidian Trickle Charge Kit User Guide
- June 4, 2024
- ZAMP SOLAR
Table of Contents
25W OBSIDIAN TRICKLE CHARGE KIT
QUICK START GUIDE
CONTENTS
A. 25W Obsidian module with 8AW controller mounted
B. MFT3007 (Universal Mounting Hardware)
C. Magnet set for mounting feet (MFT3013)
D. 15ft ATP Extension (ITC3007)
E. Fused Alligator clips (ITC1028)
F. ITC1032 (Fused 10awg, ring terminal wire for permanent installation on a
battery)
NOT INCLUDED
– Mounting screws for the charge controller
TOOLS NEEDED
– Drill
– 7/16” Socket, Nut Driver, or Open-Ended Wrench
– 10mm Socket, Nut Driver, or Open Ended Wrench
– #2 Phillips Head Screwdriver
STEP 1: SET BATTERY PROFILE
(SKIP IF USING AGM BATTERY)
STEP 2: ATTACH MOUNTING FEET
Click HERE for the Mounting Feet Instruction Guide
*Follow steps 2-4 on install instructions
STEP 3: ATTACH MAGNETS (IF USED)
Click HERE for Magnet Mounting Feet Instruction Guide
STEP 4: MOUNT YOUR PANEL
STEP 5: CONNECT TO YOUR BATTERY
Option 1: Permanent Battery Mount
A. Connect the positive (red) ring terminal to the positive terminal of the
battery.
B. Connect the negative (black) ring terminal to the negative terminal of the
battery.
Option 2: Alligator Clips
A. Connect the positive (red) Alligator Clip to the positive terminal of the
battery.
B. Connect the negative (black) Alligator Clip to the negative terminal of the
battery.
*Use provided 15ft extension if the extended distance is required between panel and battery.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>