ZAMP SOLAR USP1008 Sidewall Port for Unregulated Portables User Guide
- June 4, 2024
- ZAMP SOLAR
Table of Contents
ZAMP SOLAR USP1008 Sidewall Port for Unregulated Portables
TOOLS NEEDED
- Drill
- 1″ hole saw
- 7/16″ socket, nut driver or open ended wrench
- 9/16″ socket, nut driver or open ended wrench
CONTENTS
- ATP Sidewall port with 15ft wire harness
- Peel and Stick Gasket
- ATP Receptacle Boot
- Mounting Screws for Sidewall port
NOT INCLUDED
- Solar Circuit Breaker
- Included with some kits
- Negative junction post
- Included with some kits
INSTALL SAFETY
- NOT FOR DIRECT CONNECTION TO BATTERY
- Install ring terminals to solar side of charge controller as detailed
STEP 1: WIRE THE SIDEWALL PORT
- Ensure solar panels are not connected at this time.
- Identify location for sidewall port install.
- Drill hole using the 1″ hole saw.
- Zamp solar recommends using a 1″ grommet to protect the wiring from abrasion.
- Run wires through the drilled hole.
- Choose a wiring option below.
Option 1: Install with a Solar Circuit Breaker
- A. Using the 7/16″ socket, connect the positive (red) wire to the terminal labeled “BAT” on the Circuit Breaker.
- This should be on the same terminal as the positive wire coming from your roof cap.
- B. Connect the negative (black) wire to the negative junction post.
- This should be on the same terminal as the negative wire coming from your roof cap.
Option 2: Install without a Solar Circuit Breaker
- A. Cut off ring terminals.
- B. Using wire strippers, strip back wires approximately 1/2″
- C. Connect the positive (red) wire to the positive solar input on the charge controller
- D. Connect the negative (black) wire to the negative solar input on the charge controller.
STEP 2: MOUNT THE SIDEWALL PORT
- Peel the white protective layer off of both sides of the included gasket and stick one side onto the bottom of the side wall port.
- For increased longevity, apply self-leveling sealant around the perimeter of the sidewall port that will be in contact with the vehicle.
- Mount the sidewall port in place using proper fasteners.
ZampSolar.com
541-728-0924
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>