V-TAC VT-1121 LED AR111 Light Instruction Manual
- June 4, 2024
- V TAC
Table of Contents
V-TAC VT-1121 LED AR111 Light
TECHNICAL DATA
INTRODUCTION & WARRANTY
Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installing and keep this manual handy for future reference. If you have any another query, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at the best. The warranty is valid for 2 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours Daily operation. Usage of product for 24 Hours a day would void the warranty. This product is warranted for manufacturing defects only
WARNING!
- Please make sure to turn off the power before starting the installation.
- Installation must be performed by a certified person.
- The light source of this luminaire is not replaceable, when the light source reaches its end of life the whole luminaire should be replaced.
- Please connect with the driver properly before connecting main supply.
- The lighting should be located in dry area.
- Proper grounding should be ensured throughout the installation
CHANGING THE REFLECTOR DIAGRAM
STEPS TO REPLACE THE REFLECTOR
- Push the clip on the back of the fixture.
- Remove the reflector.
- Install the new reflector.
- Push the clip, into the fixture.
INSTALLATION DIAGRAM
INSTALLATION INSTRUCTION
- Switch off the power.
- Install the AR111 light source on the fitting [non-included].
- Connect the wire of the driver to mains(220-240V) in a correct way and put the driver into the ceiling properly.
- Switch on the power if above steps done properly without any mistakes.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>