POWR-LITE CD25W-NW-W-IP65 LED Can Downlight Instruction Manual

: October 30, 2023
: POWR-LITE

Table of Contents

POWR-LITE CD25W-NW-W-IP65 LED Can Downlight
Product Information
Product Usage Instructions
Important Safety Instructions
Installation Procedure
Surface Mounted Installation
Read User Manual Online (PDF format)
Download This Manual (PDF format)

POWR-LITE CD25W-NW-W-IP65 LED Can Downlight

Certainty at The Speed of Light

Product Information

The LED CAN DOWN LIGHT model CD25W-NW-W-IP65 is a high-quality lighting fixture suitable for both indoor and outdoor use. Its dimensions are 130mm in diameter and 115mm in height, making it easy to install in a variety of settings. The product is designed for surface-mounted installation and comes with a professional electrician for installation and maintenance.

Important Safety Instructions
Please follow these important safety instructions before installing the LED CAN DOWN LIGHT:

Switch off the power supply before beginning installation.
Switch on the power supply only after the complete installation and examination of the circuit.
Use a professional electrician for installation and maintenance.

Product Usage Instructions

Follow these steps to install the LED CAN DOWN LIGHT:

Turn off the power supply.
Select a suitable location for surface-mounted installation.
Align the fixture with the selected location and mark the position of the screw holes.
Drill holes for the screws and insert wall plugs.
Fix the fixture to the wall using screws and screwdriver.
Connect the wires to the fixture according to the wiring diagram:
- L: Live wire (switched)
- N: Neutral wire
- Earth: Earth wire
Turn on the power supply and test the fixture to ensure it is working properly.

Note : The CD25W-NW-W-IP65 LED CAN DOWN LIGHT model is designed for indoor and outdoor use and comes with an IP65 rating, which means it is dust- tight and can withstand low-pressure water jets from any direction.

Important Safety Instructions

Basic safety precautions should always be followed when installing, including the following:

Read all instructions.
Licensed electrician for installation only
Always ensure the power is OFF and the fitting has cooled down before performing any maintenance, cleaning, changing the globe or adjustment to the fitting.
not install any luminaire near the heat source.
not exceed the nominal supply voltage or amperage ratings.
To avoid injury or damage to the fitting, please ensure that power leads and screws are secure before connecting the power.