amazon basics B08P6 Series Wireless Mouse Instruction Manual
- June 9, 2024
- amazon basics
Table of Contents
amazon basics B08P6 Series Wireless Mouse
Important Safeguards
DANGER Risk of suffocation! Keep any packaging materials away from children and pets – these materials are a potential source of danger, e.g. suffocation.
CAUTION Avoid looking directly into the beam.
Read these instructions carefully and retain them for future use. If this product is passed to a third party, then these instructions must be included.
- For domestic, office and indoor use only.
- Only use this product for its intended use.
- Do not use this product it damaged.
- Do not insert any foreign objects into the inside of the casing.
- Protect the product from extreme temperatures, hot surfaces, open flames, direct sunlight, water, high humidity, moisture, strong jolts, flammable gases, vapors and solvents.
- The product does not work on glass surfaces.
Battery Warnings
- Keep batteries out of the reach of children. In particular, keep batteries which are considered Swalowable out of the reach of children. In case of ingestion of a cell of battery seek medical assistance promptly. Swallowing batteries can cause chemical burns, perforation of soft tissue, and in severe cases can cause death. They need to be removed immediately it swallowed.
- Do not allow children to replace batteries without adult supervision.
- Always insert batteries correctly with regard to polarity(+ and-) marked on the battery and the equipment. When batteries are inserted in reverse they might be short-circuited or charged. This can cause overheating, leakage, venting, rupture, explosion, fire and personal injury.
- Do not short-circuit batteries. When the positive(+)and negative(-) terminals of a battery are in electrical contact with each other, the battery becomes short-circuited. For example loose batteries in a pocket with keys or coins, can be short-circuited. This can result in venting. leakage, explosion, fire and personal injury.
- Do not charge batteries. Attempting to charge a non-rechargeable (primary) battery can cause internal gas and/or heat generation resulting in leakage, venting, explosion, fire and personal injury.
- Do not force discharge batteries. When batteries are force discharged by means of an external power source the voltage of the battery will be forced below its design capability and gases will be generated inside the battery. This can result in leakage, venting, explosion, fire and personal injury.
- Do not mix new and used batteries or batteries of different types or brands. When replacing batteries, replace all of them at the same time with new batteries of the same brand and type. When batteries of different brand or type are used together or new and used batteries are used together, some batteries might be over-discharged/ force discharged due to a difference of voltage or capacity. This can result in leakage, venting, explosion, fire and personal injury.
- Exhausted batteries should be immediately removed from equipment and properly disposed of. When discharged batteries are kept in the equipment for a long time electrolyte leakage can occur causing damage to the equipment and/or personal injury.
- Do not heat batteries. When a battery is exposed to heat, leakage, venting, explosion or fire can occur and cause personal injury.
- Do not weld or solder directly to batteries. The heat from welding or soldering directly to a battery can cause leakage, venting, explosion or fire, and can cause personal injury.
- Do not dismantle batteries. When a battery is dismantled or taken apart, contact with the components can be harmful and can cause personal injury or fire.
- Do not deform batteries. Batteries should not be crushed, punctured, or otherwise mutilated. Such abuse can cause leakage, venting, explosion or fire and can cause personal injury.
- Do not dispose of batteries in fire. When batteries are disposed of in fire, the heat build-up can cause explosion and/or fire and personal injury. Do not incinerate batteries except for approved disposal in a controlled incinerator.
- Always select the correct size and grade of battery most suitable for the intended use. Information provided with the equipment to assist correct battery selection should be retained for reference.
- Clean the battery contacts and those of the equipment prior to battery installation.
- Remove batteries from equipment which is not to be used for an extended period of time.
Cleaning and Storage
NOTICE I Do not immerse the product in water or other liquids. Never hold the product under running water.
- To clean the product, wipe with a soft, slightly damp cloth.
- Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp utensils to clean the product.
- Store the product in its original packaging in a dry area. Keep away from children and pets.
FCC Compliance Statement
-
This device complies with Part 1 S of the FCC Rules.
Operation is subject to the following two conditions: -
this device may not cause harmful interference, and
-
this device must accept any interference received, including interference that may cause undesired operation.
-
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 1 S of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Canada IC Notice
- This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
- This Class B digital apparatus complies with Canadian CAN ICES-003(B) / NMB-003(B) standard.
Simplified EU Declaration of Conformity
- Hereby, Amazon EU Sari declares that the radio equipment type B08P6PL5R3, B08P6NDDGZ,B08P6P1 CMD, B08P6RG5CS is in compliance with Directive 2014/S3/EU.
- The full text of the EU declaration of conformity is available at the following internet address: https://www.amazon.co.uk/amazon_private_brand_EU_compliance
Simplified UK Declaration of Conformity
Hereby, Amazon EU SARL, UK Branch declares that the radio equipment type B08P6PL5R3, B08P6NDDGZ,B08P6P1 CMD, B08P6RG5CS is in compliance with The Radio Equipment Regulations 2017. The full text of the UK declaration of conformity is available at the following internet address: https://www.amazon.co.uk/amazon_private_brand_EU_compliance
Disposal
The Waste Electrical and Electronic Equipment (WEEE) Directive aims to minimise the impact of electrical and electronic goods on the – environment, by increasing re-use and recycling and by reducing the amount of WEEE going to landfills. The symbol on this product or its packaging signifies that this product must be disposed of separately from ordinary household wastes at its end of life.
Be aware that this is your responsibility to dispose of electronic equipment at recycling centers in order to conserve natural resources. Each country should have its collection centers for electrical and electronic equipment recycling. For information about your recycling drop-off area, please contact your related electrical and electronic equipment waste management authority, your local city office, or your household waste disposal service.
Battery Disposal
Do not dispose of used batteries with your household waste. Take them to an
appropriate disposal/collection site.
To learn more about recycling batteries, visit: call2recycle.org/what- can-i-recycle
Specifications
-
Power supply
B08P6PLSR3/ B08P6P1 CMD/
B08P6RG5CS:
3V–2x 1.5 V AAA (LRO3)
BO8P6NDDGZ:
1.5 V 1x 1.5 V AA (LR6) -
Net weight
B08P6PL5R3:
approx. 0.22 lbs (100.6 g)
B08P6NDDGZ:
approx. 0.15 lbs (68 g)
B08P6P1CMD/ B08P6RG5CS:
approx. 0.137 lbs (62 g) -
Dimensions
( L x W x H)
B08P6PL5R3:
approx. 4.57 x 3.24 x 2.1″
(116.3 x 82.5 x 53.4 mm)
B08P6NDDGZ:
approx. 4.15 x 2.67 x 1.56″
(105.5 x 68 x 39.6 mm)
B08P6P1CMD/ B08P6RG5CS:
approx. 3.93 x 2.28 x 1.37″
(100 x 58 x 35 mm) -
OS compatibility
Windows and Mac -
Transmission power
1 mW -
Frequency band
2.4GHz
B0SP6NDDGZ
- Bluetooth® version 5.1
- Bluetooth® range 32 ft (10 m)
The Bluetooth® word mark and Logos aBrleu erteogoistthe rSeIGd ,t rInacd. Amanda ranks yo wusnee do fb you ch marks by AmazonBasics is under license. Other trademarks and trade names are those of their respective owners. amazon.com/AmazonBasics
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>