TOW SMART 1472, 1473 Mini Clearance Light Instruction Manual
- October 30, 2023
- TOW SMART
Table of Contents
TOW SMART 1472, 1473 Mini Clearance Light
Product Information: MINI CLEARANCE LIGHT
The MINI CLEARANCE LIGHT is a product manufactured by Winston Products, LLC. This product is available in two different models: PART #1472 and PART #1473. The product is designed to provide added visibility and safety to trailers, especially during low-light conditions. The product comes with an installation guide, which provides step-by-step instructions on how to install the product.
Product Usage Instructions
Before installing the MINI CLEARANCE LIGHT, ensure that you have all the necessary tools and equipment needed for the installation. These tools include a drill, drill bits, screws, and a screwdriver.
- Start by selecting the location where you want to install the clearance light on your trailer. Ensure that this location is visible from all angles.
- Using the drill and drill bit, make a hole in the selected location on your trailer. The hole should be large enough to fit the clearance light.
- Insert the clearance light into the hole and secure it in place using screws and a screwdriver.
- Connect the wiring of the clearance light to the wiring system of your trailer. This can be done by following the wiring instructions provided in the installation guide.
- Test the clearance light to ensure that it is functioning properly. If there are any issues with the product, call 1-844-295-9216 for assistance.
It is important to note that if you experience any problems with the MINI CLEARANCE LIGHT, do not return it to the retailer. Instead, call 1-844-295-9216 for assistance. Warranty information is also available upon request and can be found online at TOWSMART.COM.
READ ALL WARNINGS AND INSTRUCTIONS BEFORE INSTALLATION
WARNING: CONSULT VEHICLE AND TRAILER OWNER’S MANUAL BEFORE INSTALLATION.
CHECK FOR SENSORS, WIRES, OR COMPONENTS
BEHIND THE MOUNTING SURFACE PRIOR TO INSTALLATION.
INSTALLATION INSTRUCTIONS
-
DISCONNECT VEHICLE POWER SUPPLY.
-
SELECT SUITABLE LIGHT MOUNTING LOCATION.
-
MARK THE TWO OUTSIDE MOUNTING HOLES FOR THE LIGHT BRACKET AND DRILL HOLES.
-
CONNECT THE BLACK (POSITIVE) WIRE LEAD TO THE DESIRED 12-VOLT CIRCUIT OF THE VEHICLE.
-
MOUNT THE LIGHT BRACKET TO THE VEHICLE WITH SCREWS. FOR PROPER LIGHT FUNCTION A GROUND CONNECTION MUST BE
ACHIEVED. FOR LIGHT MODELS WITH ONLY ONE WIRE, GROUND IS ESTABLISHED THROUGH THE MOUNTING BRACKET. -
RECONNECT VEHICLE POWER SUPPLY.
-
TEST LIGHTS.
IF YOU EXPERIENCE ANY PROBLEMS WITH YOUR TOWSMART PRODUCT DO NOT RETURN THE UNIT TO THE RETAILER FROM WHICH IT WAS PURCHASED. INSTEAD, PLEASE CALL 1-844-295-9216 FOR ASSISTANCE WITH ANY PROBLEMS. WARRANTY INFORMATION IS AVAILABLE UPON REQUEST AND CAN BE FOUND ONLINE AT TOWSMART.COM
Winston Products Company
TOWSMART.COM
WINSTON PRODUCTS, LLC.
30339 Diamond Parkway
Cleveland, OH 44139