SZ J5000 Series Trampoline Instruction Manual

October 30, 2023
SZ

SZ J5000 Series Trampoline

Product Information

The trampoline is a recreational equipment that provides a fun way to exercise and spend time outdoors. It comes with a frame, T-tube connectors, upright tubes, W-type tubes, frame pad, jumping mat, steel hooks, hook loading tool, safety net, upper safety net poles with foam & top hat, lower safety net poles with foam, PVC sleeves for safety net pole, top fiberglass poles, M6x30mm screw, spanner and instruction book. The trampoline is available in three sizes: 250cm, 305cm and 366cm.

The user manual provides important safety instructions and maintenance tips for the trampoline. It is important to read the entire manual before installing and using the product. Regular inspection of the trampoline for damage and wear-sensitive parts is crucial for optimum safety. Proper maintenance of the trampoline is also important to optimize its service life.

Product Usage Instructions

  1. Before assembly, lay out all parts and check if everything is present.

  2. Follow the assembly instructions carefully.

  3. Assemble the legs by inserting the frame tubes with the bigger end into the T-tube, then insert the smaller end into the T-tube.
    Repeat until all frame and tubes are connected.

  4. Connect the leg extension tube with the W-shaped leg tubes as shown in the picture. Make sure the pin is locked. For 250cm trampoline, the upright tube is not required.

  5. Place all leg tubes inside the frame circle to line up with T-tube connectors.

  6. Lift up the frame on one side and insert leg tube into the T-tube. Repeat this step to connect all legs. Note: connect with two or more persons.

  7. Lay the jumping mat inside the frame. Ensure that bounce mat faces upwards with the logo facing where the entrance will be positioned. Attach the steel hook to the frame tube. Choose one steel hook which is next to the blue dot, attach it to the holes of the frame
    tube beside the corresponding T-tube connector by hook loading tool. Make sure the blue dot faces the T-tube connector. Repeat to attach steel hooks beside each T connector by counting the number of steel hooks and corresponding holes on frame tube.

  8. Lay the frame pad around on edge of the trampoline only with flaps hanging over the outside frame, then stick the Velcro together. Adjust the pad placement and make sure each seam aligns with each T-tube connector.

  9. Tie all black straps under safety pad to the frame.

  10. Put the elastic belts (under the pad) through the tubes like above picture elastic mesh then tie them tightly.

  11. Connect each upper safety pole and lower safety pole together by the pin and make sure the pin locked. Cover the entire pole with sleeve.

CAUTION: Read the entire manual before installing and using the trampoline!
In order to guarantee optimum safety, you should check the trampoline on a regular basis for damage and wear-sensitive parts. You must also clearly follow the instructions below.

  • As owner of the trampoline, you are responsible that all users have seen the instructions before using.
  • The trampoline must be used simultaneously by a maximum of one person.
  • Check the construction, screws, bolts and connections before using the trampoline for the first time and then on a regular basis. Check that all parts are properly connected and attached before using the machine.
  • Incorrect use can result in damage to health. Before you start training, consult your doctor to see if your health allows you to train with this trampoline.
  • Before you start using the trampoline, make sure that all sharp parts around and around the trampoline are removed.
  • In case of regular use, we advise you to check all parts and fastening parts, especially the screws and bolts, every 1 to 2 months. In order to maintain the structural safety level of the trampoline, damaged parts must be replaced immediately.
  • The trampoline is designed for use by adults. If you allow children to use the trampoline, make sure it is used correctly and supervise it at all times. If you allow children to use the trampoline, always consider their mental and physical abilities.
  • Make sure there is enough space around the trampoline, during assembly and use.
  • Ensure that the trampoline is stable and level at all times. Use an even underlay for the installation of the trampoline.
  • Keep body parts away from movable parts of the trampoline when using it.
  • Never make your own adjustments to the trampoline.
  • Never start using the trampoline immediately after eating a meal.
  • Always take a good position on the trampoline before you start jumping.
  •  Stop jumping immediately if you experience any of the following symptoms: dizziness or nausea, chest pain or other physical complaints and contact your doctor.
  • The manufacturer cannot be held liable for damage caused by improper use of the product.
  • Adjust the trampoline so that it is in a comfortable training position and does not put unnecessary strain on the body.
  • Do not use the trampoline with exceptional forces for which such a trampoline is not designed.
  • In the event of a defect, always contact the supplier.
  • Check all parts of the trampoline regularly and tighten the screws regularly. Also check for material fatigue and replace the defective parts immediately.
  • The warranty is void if the product; has not been used properly, has not been installed and maintained in accordance with the instructions, is defective due to external influences such as climate, has been modified or altered, is used for public use or parts that are not the property of Senz Sports have been replaced.

CAUTION: Proper maintenance of your trampoline is crucial in order to optimise its service life.

Parts list

SZ J5000 Series Trampoline-fig1 SZ J5000 Series
Trampoline-fig2

Assembly

  • Lay out all parts and check if everything is present

  • Assemble the legs. First insert the frame tubes with the bigger end into the T-tube, then insert the smaller end into the T-tube. Repeat untill all frame and tubes are connected.

  • Connect the leg extension tube with the W-shaped leg tubes as shown in the picture. Make sure the pin is locked (Upright tube not required for 250 cm / 8ft trampoline)

  • Place all leg tubes inside the frame circle to line up with T-tube connectors.

  • Lift up the frame on one side and insert leg tube into the T-tube. Repeat this step to connect all legs. Note: connect with two or more persons.

  • To prepare the bounce mat to be attached to the trampoline you must first attach the steel hooks. Each hook connects through 3 loops of the bounce mat. You can find blue dots on the bounce mat, choose one blue dot as the start point to connect the hooks. Working to the left or right of the start section you connect the hooks by pushing through 3 elasticated hoops on the bounce mat mesh. Hold the hook with the round hook section facing towards you and the hook facing down. Then thread the loop downwards through the first hoop, upwards through the second and then finally downwards through the third loop. All hoops should now be connected over the bar of the hook.

  • Put the beginning and end overlap together. The hook goesthrough 6pcs elastic mesh only at this place. Lay the jumping mat inside the frame. Ensure that bounce mat faces upwards with the logo facing where the entrance will be positioned.

  • Attach the steel hook to the frame tube. Choose one steel hook which is next to the blue dot, attach it to the holes of the frame tube beside corresponding T- tube connector by hook loading tool. Make sure the blue dot faces the T-tube connector. Repeat to attach steel hooks beside each T connector by counting the number of steel hooks and corresponding holes on frame tube

SZ J5000 Series Trampoline-fig6

  • Attach all other steel hooks evenly. To make assembly easier we suggest that when one adult attach the steel hooks another adult help fix the frame aside to avoid the trampoline move. Also we suggest to follow the marked number to assemble symmetrically and evenly. WARNING: In order to attach the hooks securely please use the provided tools and wear gloves to protect your hands. Trampoline is under heavy tension, more effort is required to attach the steel hooks to the frame. Be careful not to pinch fingers or slip. Serious injury may occur.
  • Lay the frame pad around on edge of trampoline only with flaps hanging over outside frame, then stick the Velcro together. Adjust the pad placement and make sure each seam aligns with each T- tube connector.

SZ J5000 Series Trampoline-fig7

  • Tie all black straps under safety pad to the frame tubes like above picture
  • Put the elastic belts (under the pad) through the elastic mesh then tie them tightly

SZ J5000 Series Trampoline-fig8

  • Connect each upper safety pole and lower safety pole together by the pin and make sure the pin locked.
  • Cover the entire pole with sleeve.

SZ J5000 Series Trampoline-fig9

  • Insert the curved enclosure poles into the two welded tubes of the leg tube one by one, as shown in the picture. Tighten the safety poles with attached screws at the bottom welded tubes. (Please use the hexagon L Spanner.)
  • Insert fiberglass poles into the top pathway of safety net one by one. Join the ends of two fiberglass poles together by silver connector. (If there is a shorter pole, then assemble it at last.)

SZ J5000 Series Trampoline-fig10

  • Put safety net onto jumping mat. Stand on the jumping mat and then pick up the safety net’s
    fiberglass poles and insert them to the black top hats one by one.

  • Find plastic hooks at the bottom of the safety net and hang them into the back of elastic mesh.

SZ J5000 Series Trampoline-fig11

Optional: Ladder instructions

SZ J5000 Series Trampoline-fig12

Maje sure the steel tube’s hook face inside and the plastic plate’s mesh face upwards. The plate is not flat, you need to keep the lower side of plate towards outside and keep the higher side of plate towards inside.

  1. Insert one steel tube into the hole of the plate. Then move the plate to the top in accordance with the hole on the steel tube.
  2. Insert another steel tube into the other end of the plate’s hole. Keep the hole of plate in align with the steel tube’s hole. Fasten them with attached screws and bolts.
  3. Attach the second one plastic plate with the same method. Cover the bottom end of ladder tube with black boots.
  4. Ladder is ready to use!

GENERAL WARNINGS

  • Read instructions before using the trampoline
  • Always close the safety net before use
  • Always jump in the middle of the trampoline
  • Only use under adult supervision
  • Replace the net every two years
  • Do not hang or jump into the safety net
  • We are not liable for any injuries that occur
  • Empty your pockets before using the trampoline
  • This trampoline is for domestic use only
  • Installation has to be done by an adult
  • Make sure that there nothing above the trampoline
  • One person at a time to avoid collision
  • No shoes on the trampoline to minimalize damage
  • Do not leave the trampoline with a jump
  • Do not use with children under 48 months
  • Do not modify the trampoline
  • Do not use the trampoline when it’s wet
  • Always check the trampoline before using it
  • Do not perform difficult jumps.
  • This trampoline is for outdoor use
  • Do not use the trampoline during health issues
  • In strong winds and gusts of wind, we recommend anchoring the trampoline with anchors or sandbags and removing the safety net and jumping mat.

ASSEMBLY INSTRUCTIONS

  1. Make sure the trampoline is placed on a flat surface and not on hard surfaces like concrete, asphalt etc.
  2. Assembling has to be done by an adult.
  3. Always make sure that there is 2 meters free space around the trampoline and 4 meters above the trampoline
  4. Make sure nothing is placed underneath the trampoline
  5. We advise to wear gloves during assembling.

MAINTENANCE

  • Check if nuts and bolts are tightened enough
  • Check if jumping mat and safety pad have no defects
  • Check if safety net has no defect
  • Replace safety net every two years
  • Modifications according instructions manufacturer
  • Use anchor set if necessary
  • Place jumping mat and safety pad inside during winter
  • While moving lift trampoline no higher than 5 cm
  • Also replace trampoline with at least two adults
  • Always keep this manual for instructions#

USER INSTRUCTIONS

  1. Begin practicing the standard jump on the trampoline. Focus on body position and jump techniques. Jump up into the air with your arms and with your feet at shoulder width.
  2. Practice how to stop jumping on the trampoline. The user has to be able to absorb the jumping power of the mat. Use both arms to stay balanced and bent the knees to lower the impact.
  3. Do not perform somersaults on the trampoline. These trampolines are not for professional use.
  4. Always jump in the middle of the jumping mat and stop bouncing when you feel out of control
  5. Never jump on to the trampoline from another object or the other way around.
     | 250 cm| 305 cm| 366 cm
    ---|---|---|---
    Max. weight| 100 kg| 150 kg| 150 kg

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals