IKEA ÄLMAREN Kitchen Mixer Tap Instruction Manual
- October 30, 2023
- Ikea
Table of Contents
ÄLMAREN Kitchen Mixer Tap
Instruction Manual
ÄLMAREN Kitchen Mixer Tap
Installation must be performed in compliance with current local construction
and plumbing regulations. If in doubt, contact a professional.
**** Switch off main shut-off valve before changing mixer tap.
Seal the open surfaces with silicone to prevent water from penetrating the
worktop upon any leaks. Silicone is not included.
IMPORTANT! Do not tighten too hard: this can damage
hoses/pipes and washers.
To comply with UK water regulations, this product shall be installed in
accordance with the following:
Inlet supply hoses shall be installed where light is excluded.
Water supplies shall be at reasonably balanced pressures from a common source
(e.g. hot and cold supplies both from the same storage or both from a supply
pipe). Where the fitting is supplied from unbalanced supplies (e.g. hot and
cold supplies from separate sources) an ‘Approved’ single check valve or some
other no less effective backflow prevention device shall be fitted immediately
upstream of both hot and cold water inlets.
Check at regular intervals to make sure that the installation is not
leaking.
Before
use: Unscrew the Aerator/Flow Guide with a coin and allow the water to run
freely for a few minutes. Then screw the Aerator/Flow Guide back in place up
to the stop DO NOT OVER TIGHTEN.
© Inter IKEA Systems
AA-2258903-2
2022-10-26
B.V. 2020
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>