DOMOTICA Remote Control Programming Instructions
- October 30, 2023
- DOMOTICA
Table of Contents
DOMOTICA Remote Control Programming
Product Information: DOMOTICA Remote Control
The DOMOTICA Remote Control is a device that allows users to control their ECB control box wirelessly. The remote control comes with a receiver that needs to be connected to the ECB control box. The receiver has a red LED indicator that lights up when it is in use. The remote control has two buttons, an on/off button, and a left button.
Product Usage Instructions
- Connecting the Receiver: The first step is to connect the receiver to the ECB control box. To do this, unscrew the connection cover from the ECB control box. Then connect the wiring as follows:
- Blue wire connects to N (zero)
- Black wire connects to L1(phase)
- Brown wire connects to 4
- Purple wire connects to 2
- Programming the Receiver: To program the receiver, push the on/off button of the receiver with a screwdriver. The red LED will light up. Then push the left button of the remote control once, and the red LED on the receiver will flash 2 times. Push the on/off button of the receiver with a screwdriver again, and the LED will go out. The receiver is now programmed and ready for use.
- Resetting the Receiver: If you need to reset the receiver, push the on/off button of the receiver with a screwdriver. The red LED will light up. Hold the on/off button for 5 seconds, and the LED will flash 5 times. Wait for 5 seconds until the red LED goes out. The receiver is now reset and can be programmed again.
Note: Always follow the instructions carefully while programming or resetting the receiver. If you face any issues, refer to the user manual or contact customer support for assistance.
Programming DOMOTICA remote control
-
Receiver domotica connect to ECB control box:
Unscrew the connection cover from the ECB control box.
Connect the wiring as described
below.
Blue = N (zero)
Black = L1(phase) Brown = 4
Purple = 2 -
Receiver programming:
Push with a screwdriver once of the on / off button of the receiver and the red LED will light up.
Then push once on the left button of the remote control and the red LED flashes 2 times. Push with a screwdriver once on the on / off button and the LED goes out.
Receiver is now programmed and ready for use. -
Receiver reset:
Push with a screwdriver once on the on / off button of the receiver and the red LED will be light up.
Hold the on / off button for 5 seconds and the LED flashes 5 times. Wait for 5 seconds until the red LED goes out.
The receiver is now reset and can be programmed again.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>