DELTACO QI-1031 Wireless Car Charger with IR Sensor User Manual

DELTACO QI-1031 Wireless Car Charger with IR Sensor

Safety instructions

1. Keep the wireless charger away and protected from water and other liquids.
2. To clean the charger use a dry cloth and make sure it is not connected to a power supply.
3. Environment temperature should be: -20°C to +45°C. The following situations can cause failures like: high temperature/no or slow charging:
4. The connected adapter or USB port does not have enough power output.
5. The charging cable it is not compatible with the power adapter’s output.
6. The phone case is too thick, recommended phone case thickness is 2-3mm.
7. There is metal or a magnet on the back of the phone or phone case.
8. The phone is not placed at the center of the wireless charger.
9. The phone does not support Qi wireless charging.

Compatible devices

For 10W fast wireless charging:
QC2.0/3.0 adapter or adapter with 9V output is required, otherwise it will give 5W power. Compatible with all devices with Qi charging built-in or with an accessory/add on (Qi wireless receiver).

Overview

1. IR sensors
2. LED indicators
3. Manual open lever buttons

Blue LED indicates normal work status. Flashing red LED indicates that it is not functioning properly. See the safety section for possible reasons and solutions.

Installation (AC vent)

When using the AC-fan guard make sure to only use cold AC or have the vent closed when using warm AC to prevent overheating while charging.

Installation (Suction cup)

1. 360° rotation nut.
2. Finger screw for adjusting the telescopic arm.
3. Suction cup
4. Nut to adjust the angle
5. Buckle to fasten/lock the suction cup

Charging and usage

Connect the cable to the wireless charger and to the car charging adapter. To use fast charging, the car charging adapter must support Quick Charge 2.0/3.0.

Note: A car charging adapter is not included in the package.

• Put your phone in front of the IR sensor and the levers will automatically open and then close themselves after 3 seconds.

• The arrows show the location of the manual open buttons. Press either of the buttons on the side to open the levers. The levers close themselves automatically after 3 seconds.

Built-in battery
The charger has a built-in battery that lasts about 20 mins after being disconnected from the power supply. It is intended to allow you to open the levers just after you have turned off your car.

Support

More product information can be found at www.deltaco.eu. Contact us by e-mail: help@deltaco.eu.

SIMPLIFIED EU DECLARATION OF CONFORMITY

The simplified EU declaration of conformity referred to in Article 10(9) shall be provided as follows: Hereby, DistIT Services AB declares that the radio equipment type wireless device is in compliance with Directive 2014/53/EU. The full text of the EU declaration of Conformity is available at the following internet address: All DoCs can be found on the product’s specific website, to access it go to: https://www.deltaco.se/produkter/xx (just change xx to the article number, for example, https://www.deltaco.se/produkter/TWS-111) Then click on the tab “Info/Certifikat”.

• DistIT Services AB, Glasfi bergatan 8, 125 45 Älvsjö, Sweden

References

• deltaco.eu
• Aurdel - Distributør av den nyeste og beste teknologien
• Aurdel - Distributør av den nyeste og beste teknologien
• deltaco.se/
• Alla produkter
• deltaco.se/produkter/TWS-
• STREETZ Trådlösa in-ear hörlurar med laddningetui, BT 5, TWS, vit
• deltaco.se/produkter/xx

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>