Halla Lipo80 Interior LED Luminaires Installation Guide
- October 30, 2023
- Halla
Table of Contents
Halla Lipo80 Interior LED Luminaires
Product Information
The product is a luminaire that requires authorized specialists for installation. The luminaire has a light source that can only be replaced by the manufacturer, its contractual service technician, or a similarly qualified person. The manufacturer is not responsible for the incorrect use and assembly of its products. The luminaire must not be covered with insulating material.
Specifications
- Model Numbers: 05-200(500)*-G
- Length (L): 561mm to 4488mm depending on the model number
- Minimum Distance from Surface (s): 90mm
- Minimum Distance from Lipo80: 50mm
- Minimum Distance from Wall: 200mm
- Maximum Distance from Wall: 30mm
- Power Supply: On/Off with dimming feature
Product Usage Instructions
For proper usage of the luminaire, follow these instructions:
Installation
The installation must be carried out by authorized specialists only. Always switch off the power supply before carrying out any maintenance. Replacing the Light Source The light source can only be replaced by the manufacturer, its contractual service technician, or a similarly qualified person.
Distance from Surface, Lipo80, and Wall
- The minimum distance from the surface (s) should be 90mm.
- The minimum distance from Lipo80 should be 50mm.
- The minimum distance from the wall should be 200mm.
- The maximum distance from the wall should be 30mm.
Power Supply
The luminaire is equipped with an On/Off power supply with a dimming feature. To turn the luminaire on or off, use the On/Off switch. To adjust the brightness, use the dimming feature. Following these instructions will ensure the proper usage and maintenance of the luminaire.
Installation Instruction
Assembly Procedure
Maintenances
- The light source in this luminaire may be replaced only by the manufacturer or its contractual service technician or a similarly qualified person!
- The installation may only be carried by authorized specialist. Always switch-off the power supply before carrying out any maintenance.
- The manufacturer is not responsible for the incorrect use and assembly of its products.