MACC NEW 315 EDV Manual Circular Saw Owner’s Manual
- October 30, 2023
- MACC
Table of Contents
MACC NEW 315 EDV Manual Circular Saw
Product Information
The NEW 315 EDV is a device that is designed for cutting materials. It comes with an electrical coolant pump that has a power rating of 0.06 kW. The device also has a jet breaker for the blade lubrication, a sliding countermovement for wider cutting capacity, a bar support arm, and a bar stop. The device has an overall dimension of 1475 mm x 1000 mm x 1150 mm. It also comes with service tools, an instruction manual, and spare parts list. The device has a 24V low voltage installation with hold-to-run head control handle.
Technical Data
The device has the following technical data:
- Electrical coolant pump: 0.06 kW
- Blade size: a x b (65 x 90, 85, 70 x 120)
- Power rating: 1.5 – 2.2 kW
- Speed: 40 – 80 rpm
- Overall dimensions: 1475 mm x 1000 mm x 1150 mm
- Weight: 193 kg
Product Usage Instructions
To use the NEW 315 EDV device, follow these steps:
- Ensure that the device is properly installed and connected to a power source.
- Turn on the device by using the hold-to-run head control handle.
- Adjust the blade size according to the material that needs to be cut.
- Use the bar support arm and bar stop to secure the material in place.
- Activate the electrical coolant pump to lubricate the blade during the cutting process.
- Use the service tools as needed to maintain the device.
- When finished, turn off the device and disconnect it from the power source.
Note : Additional accessories such as a single-phase or three-phase electric motor, a pneumatic vice with pedal control, and a steel pedestal can be requested separately if needed.
TECHNICAL DATA
- Manual circular saw for metal cutting
- Movable head 45° left and 45° right
- Reduction unit in oil bath
- Adjustable blade protection clutch
- Blade holder shaft on bearings
- Double hinged pivot with eccentric bush
- Adjustable stops -45° 0° +45°
- Quick locking double vice complete with anti-burr device
- Electrical coolant pump 0,06 kW
- Jet breaker for the blade lubrication
- Sliding countervice for wider cutting capacity
- Bar support arm
- Bar stop
- Service tools
- Instruction manual and spare parts list
- 24V low voltage installation with hold-to-run head control handle
- Overall dimensions: 1475 mm x 1000 mm x 1150 mm
Accessories upon request
- Single-phase electric motor 40 rpm
- Three-phase electric motor 20 – 40 rpm (1,32-1,91 kW)
- Pneumatic vice with pedal control
- Steel pedestal
- Blade
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>