Ocean Hunter Seeker Crayfishing Torch Instruction Manual
- October 30, 2023
- Ocean Hunter
Table of Contents
Seeker Crayfishing Torch
Instruction Manual
SPECIFICATIONS:
- Model: Seeker
- Bulb: CREE XM-L2 U2 (CCT 6500 Kl
- Max brightness level: 650 lumens
- Reflector: glossy aluminum reflector
- Lens: 4 mm toughened glass
- Body material: durable aircraft-grade aluminum
- Angle of light beam: 16º hot spot
- Surface treatment: premium anodizing
- Battery: 18650 Li-ion battery with BMS * 1
- With battery over -discharging protection, polarity reversing protection
- Operation voltage: 4.2 V to 3.0 V
- Waterproof: 60 Meters underwater
- Dimensions: 135 mm (length) 28 mm (dia. of light head) 26 mm(dia. of light body)
- Weight in air: approx. 105 g. (without battery); approx.154 g. (with battery)
- Underwater weight: approx. 80 g. (with battery)
POWER INDICATOR:
Ring-shaped power indicator surrounding the switch lights up in green, or
yellow, or red, when power capacity is above 70%, or between 70-40%, or
between 4010%. It flashes in red for power capacity between 10-5%, and
switches off automatically when the power capacity is below 5%.
LOW BATTERY WARNING:
The light flashes 3 times if the power capacity reaches 10-5%; it repeats
after 5 seconds, and then switches to lower brightness. The light switches off
automatically when the power capacity is less than 5% .
BATTERY INSTALLATION:
- Hold the light with its head pointing upward, unscrew the light head.
- Remove used battery and replace with fresh one per polarity signs.
- Screw light head down. Do not overtighten to break the 0-ring.
BATTERY CHARGING:
- Direct USB re-chargeable battery.
- After the battery is fully charged, unplug the USB charging lead, use or store the battery properly.
CAUTION:
- Please never attempt to repair or modify the light yourself.
- Please handle illuminants with care to avoid breakage. While being hit on, illuminants can break or splinter. Splinters can cause eye and skin injuries.
- Please check the light regularly for sharp edges, scratches or damages to the surface or 0-ring, as this can cause the light to flood under pressure. PLEASE LUBRICATE THE 0RING, AND REPLACE IT TIMELY. (Please avoid applying lubricant to circuit board or battery compartment cross section, which may affect the conduction.)
- Please rinse the product surface thoroughly after each use, and allow sufficient time for it to dry both inside and outside before storage.
- Please remove the battery from battery compartment for transport or storage. Do not lay the battery in a fire or expose it to direct heat. Do not wet or hit the battery. Please charge it after each use, or once every three months, to avoid over-discharging.
- Please never leave the light unattended when it is on.
- Please keep the device out of the reach of children and pets.
- Please never shine the light to human or pet’s eye.
- It is recommended to use the battery with re/discharge protection circuit or BMS (Battery Management System ) for this light.
- ln case of accidental flooding, please remove the battery, and dry the light and battery compartment as soon as possible, to prevent the secondary damage.
WARRANTY RETURN POLICY:
Please contact your local distributor or retailer for information on how to
handle your warranty items.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>