ENCHEN Aurora T3 Electric Toothbrush User Manual
- October 30, 2023
- ENCHEN
Table of Contents
- Product Introduction
- Product Specification
- Packing Specification
- Product Components
- Product Feature
- Charging Instructions
- Three Cleaning Modes
- Using Steps
- Environmental Protection
- Battery Removal
- Precautions
- Warranty Description
- Trouble Shooting
- Product Warranty Card
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
**ENCHEN Aurora T3 Electric Toothbrush
**
Product Introduction
Thank you very much for using the product manufactured by our Company. In
order to ensure you have a more comfortable experience of the toothbrush,
please carefully read the User Manual of the toothbrush.
With the fine bristles and the sonic vibration at higher frequency, this
electric toothbrush can clean all parts of teeth deeply, and fade out the
dental plaque and yellow teeth effectively, so as to achieve the oral
cleanliness.
Product Specification
Product Name | Electric Toothbrush |
---|---|
Model | Aurora T3 |
Rated Power | 1.2W |
Input Parameter | 5V 1A |
Charging Time | Wireless charging for approximately 18 hours |
Battery | 2500mAh |
Operating Time | 180 days |
Packing Specification
Item | Host | Brush Head | Charging Cable | Charging Base | User Manual |
---|---|---|---|---|---|
Qty | 1 | 2 | 1 | 1 | 1 |
Note:
Pictures and related features of products shown in this manual are for
reference only. Please refer to the actual product. The company reserves the
right to change product specifications without notice.
Product Components
Product Feature
- IPX7 Waterproof Design.
- Three Cleaning Mode
- Memorization Function: to record the gear you used last time.
- In the power-off state, long press the power button for 5 seconds, and the white lamp flashes twice to enable/disable the travel lock function.
- In the power-on state, long press the mode button for 3 seconds to enable/disable the tooth overpressure protection.
- Built-in Smart Timer: Remind you to change brushing area every 30 seconds.
- Extra-long Operating Time: Re-chargeable battery lasts 180 days if you use the toothbrush twice a day for two minutes each time.
Charging Instructions
Low Battery: The red signal light flashes, prompting user to charge, and the
toothbrush can be used normally for a short period of time; if the battery is
too low, the red signal light flashes, and the toothbrush cannot be used.
In such case, charge the toothbrush as soon as possible.
When charging: The white signal light flashes.
*While charging, the toothbrush cannot be used.
Charging time: about 18 hours. When fully charged, the white signal light is always on.
Charging Method:
Connect the 5V Type-C adapter to the charging base, and place the toothbrush
on the charging base.
Note: In order to protect the Product, do not charge with an adapter at the voltage higher than 5V, and charging must be done with a 5V adapter or a USB port on the computer.
Three Cleaning Modes
- White Light CLEAN (Clean Mode) with three gears (weak, medium and strong) : to clean the teeth thoroughly and every area of the oral cavity.
- Purple Light MILDER (Sensitive Mode) with three gears (weak, medium and strong) : This mode is recommended for the first use of a sonic toothbrush. You will feel more comfortable with it if having toothache and tooth hypersensitivity.
- Yellow Light MASCARE (Gum Health Care Mode) with three gears (weak, medium and strong) : Highly frequent rhythmic vibrations can remove coffee, tobacco and tea stains. This mode is suitable for people with stubborn tooth stains.
Note: This machine has a memorization function, which can automatically saves the last used gear.
Using Steps
-
Carefully insert the toothbrush head into the output shaft and fix it as required.
-
Before using, take an appropriate amount of toothpaste on the brush head, soak it with water then put it into the mouth.
-
Turn on the switch and select the appropriate gear according to your needs.
-
Let the bristles at 45° to the gum line, move the toothbrush slowly.
-
Hold the main body of the toothbrush lightly and move it slowly in a circular motion. Do not press or scrub it too hard.
-
After brushing, please rinse your mouth and the toothbrush head with water.
Environmental Protection
The built-in rechargeable battery may contain substances that pollute the environment. Before disposing of the product, be sure to remove the battery or send the product to an officially designated recycling station for disposal of the battery. You can also send the discarded products to the recycling department designated by the company, and the maintenance department will decompose and recycle the battery.
Warning
Do not short-circuit the battery in case the battery will burn out and cause a
fire.
Do not throw the battery into a fire to prevent explosion or release of toxic
substances
Battery Removal
-
Twist the bottom cover vigorously until the internal buckle dislocates and makes a sound of cracking.
-
Remove the end cover.
-
Use tweezers or pliers to clamp the buckle inward, which is pointed by the arrow.
-
Push the motor shaft downward so that central unit of toothbrush can be taken out by clamping the buckle inward.
-
Take the central unit of Toothbrush out.
-
Use a flat-head screwdriver to pry open the circuit board and remove the battery.
Precautions
When connecting the main body to the charging device, please check whether the
voltage marked on the product matches the voltage of the charging device
first.
Replace the toothbrush head every three months. If the toothbrush head looses
due to some damage, please replace it in time.
Any physically, perceptual and mentally impaired customers (including
children) is not recommended to use this product unless they are under the
supervision and guidance of their guardians.
If you are going through oral treatment or have other symptoms in your mouth,
please consult your dentist before using this product. This product is only
used for cleaning teeth, please do not use it for other purposes.
If you feel unwell after using it and the symptom doesn’t subside, or if there
is continuous bleeding, please stop using it and to consult your dentist.
Warranty Description
- Since the date of purchasing this product, the main body is under free warranty service for one year, but consumables such as brush heads are not included in the warranty.
- Product failure and damage caused by using the wrong current and voltage, plugging the product into an unreasonable socket and other man-made damages; fire/earthquake/ flood/ lightning and other natural disasters/- public hazards or power/voltage abnormalities.
- Warranty termination during the warranty period:
A.The product is repaired or disassembled by non-company personnel
B.The product uses non-company parts
C.Product damage caused by non-domestic use (such as industrial/commercial use).
The free warranty service for the replacement parts or the whole machine within the warranty will terminate at the same time as the free warranty service period of this product dues.
Unless there are indeed relevant laws and regulations, the company is not responsible for any other requirements.
Trouble Shooting
Problem | Cause | Measure |
---|---|---|
Reduced vibration intensity | 1.The toothbrush is forced on teeth 2.The brush | |
head is pressed into the main body too deeply | 1. Gently place the brush head |
on teeth.
2. Remove the brush head from the handle and put it on the output shaft again.
Keep a distance between the brush head and the handle.
Even if it is charged, the working time of the toothbrush is very short| 1. The main body is not placed vertically on the charger, so it is not charged.
2. Low battery
| Place the main body vertically so that its bottom is contacting the charger,
and confirm whether the indicator light is on.
The toothbrush is not working| 1.Charging time is not enough. 2.The battery
has reached the end of its life.| 1. Please charge.
2. Replace the battery at our company.
Product Warranty Card
Name|
---|---
Telephone|
Time of Purchase|
Product Model|
Address|
Description of Fault|
Please fill in with your information carefully, please send this card together with the Product to our repair center, our Company will provide testing repair or replacement service. Note: For the terms and conditions of warranty in detail, please refer to the operating instruction!
AMEUDA TECHNOLOGY CO., Ltd.
Address:Room 2102, Comprehensive Building ,
Jiangjin Comprehensive Free Trade Zone,
No.88, Maya Avenue, Luohuang Town,
Jiangjin District, Chongqing City,China