Emerson CKS1500 SmartSet Clock Radio with Auto Time Setting System Owner’s Manual

CKS1500 SmartSet Clock Radio with Auto Time Setting System

Product Information

The product is a CKS1500 clock radio with AM/FM radio and alarm features. The clock radio has a front and top panel for controls and display, a rear panel with a speaker, FM antenna, AC adapter, and back up battery compartment. It also has a CLOCK SET button, TUNE- and TUNE+ buttons for adjusting the time, date, and year settings, and an ON/OFF button for turning the radio on and off. The clock radio can also be set with alarms and has a SNOOZE/DIMMER/SLEEP button for controlling these features.

Product Usage Instructions

1. Remove any descriptive labels, stickers, or protective films on the front or top of the cabinet, if any.
2. Read and keep the instructions. Heed all warnings and follow all instructions.
3. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
4. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. The plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. Do not use with an extension cord unless the plug can be fully inserted. Objects filled with liquids, such as vases, shall not be placed on the apparatus.
5. The mains plug is used as a disconnect device and should remain readily operable during intended use. In order to disconnect the apparatus from the mains completely, the mains plug should be disconnected from the mains socket outlet completely. The battery shall not be exposed to excessive heat such as sunshine, fire, or the like. Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
6. To check the current year-date-day of week-time settings, press briefly the CLOCK SET button repeatedly to cycle through each setting.
7. To set the year, press and hold the CLOCK SET button until the year flashes. Use the TUNE- or TUNE+ button to adjust the year. Press the CLOCK SET button to confirm.
8. To set the date, press the CLOCK SET button again and release. The date will flash. Use the TUNE- or TUNE+ button to adjust the month. Press the CLOCK SET button again and release. The date will flash again. Use the TUNE- or TUNE+ button to adjust the date. Press the CLOCK SET button to confirm.
9. To set the time, press the CLOCK SET button again and release. The hour will flash. Use the TUNE- or TUNE+ button to adjust the hour (where AM indicator ‘On’ is AM, ‘Off’ is PM). Press the CLOCK SET button again and release. The minutes will flash. Use the TUNE- or TUNE+ button to adjust the minutes. Press the CLOCK SET button to confirm.
10. Note: Time zone and clock settings can only be adjusted in Standby mode, where the AM/FM Radio is disabled (i.e. the indicators of kHz and MHz are ‘Off’).
11. To adjust alarm settings, the clock radio must be in Standby mode. Use the TIME ZONE/MEM./STO. button to cycle through alarm settings and use the TUNE- or TUNE+ button to adjust them.

PRÉCAUTION: Danger d’explosion si les piles sont remplacées de facon incorrect. Remplacer les piles seulement par le méme type de pile ou l’équivalent.

Remove any descriptive labels,stickers or protective films on the front or top of the cabinet,if any.

The antenna wire

the antenna wire

LED Décor
CKS1500
To browse the SPANISH Owner’s Manual online, please visit https://www.emersonradio.com/documents/
1.) Read these instructions. 2.) Keep these instructions. 3.) Heed all warnings. 4.) Follow all instructions. 5.) Do not use this apparatus near water. 6.) Clean only with dry cloth. 7.) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8.) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat. 9.) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10.) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11.) Only use attachments / accessories specified by the manufacturer. 12.) Unplug this apparatus during lightning storms or when unused for long periods of time. 13.) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 14.) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 15.) The apparatus shall not be exposed to dripping or splashing and that no
objects filled with liquids, such as vases, shall be placed on apparatus. 16.) Mains plug is used as disconnect device and it should remain readily
operable during intended use. In order to disconnect the apparatus from the mains completely, the mains plug should be disconnected from the mains socket outlet completely. 17.) Battery shall not be exposed to excessive heat such as sunshine, fire or the like. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type.

press and hold display`Flashes’
Release

until the

TUNE-

TUNE+

Front Panel
1 2 3 4
Top Panel
12 11 10 9

AM

5

kHz

6

MHz

7

8

13 14 15 16
17

Checking the Current Year-Date-Day of Week-Time Settings Press briefly the CLOCK SET button repeatedly to see the cycle of year, date, day of week and time. To restore time display mode, leave it idle for few secs.

Setting the Year the CLOCK SET button until the Year ‘Flashes’,
Press the TUNE- or TUNE+ button to adjust the Year;

the button;

Setting the Date Press the CLOCK SET button again and release, the Date ‘Flashes’; Press the TUNE- or TUNE+ button to adjust the Month;
5 Press the CLOCK SET button again and release, the Date ‘Flashes’;
6 Press the TUNE- or TUNE+ button to adjust the Date;
Setting the Time 7 Press the CLOCK SET button again and release, the Hour ‘Flashes’;
8 Press the TUNE- or TUNE+ button to adjust the Hour (where AM indicator ‘On’ is AM, ‘Off’ is PM);
9 Press the CLOCK SET button again and release, the Minutes ‘Flashes’;
10 Press the TUNE- or TUNE+ button to adjust the Minutes 11 Press the CLOCK SET button again, or leave it idle for few tens of
seconds, to store all new settings and restore it to time display mode. NoteTime zone and clock settings can only be adjusted in Standby mode,where the AM/FM Radio is disabled(i.e.the indicators of kHz and MHz are`Off’)

Rear Panel

18 19

21
5.) AM Indicator (‘On’=AM,’Off’=PM) 6.) KHz (AM Radio) Indicator. 7.) MHz (FM Radio) Indicator. 8 9.) ON/OFF button 10.) VOL- / AL1 button 11.) TUNE- button

20
12.) CLOCK SET / BAND select button 13.) TIME ZONE/ MEM./ STO. button 14.) TUNE+ button 15.) VOL+ / AL2 button 16.) LED button 17.) SNOOZE/DIMMER/SLEEP Button 18.) Back Up Battery Compartment 19.) Speaker 20.) FM antenna 21.) AC adapter (Back Cabinet).

IMPORTANT NOTES
Turn Daylight Saving Function Off / On (in standby mode only) Daylight Saving Time is NOT observed in Hawaii, American Samoa, Guam, Puerto Rico, the Virgin Islands and in, most of Arizona, with exception of the Navajo Indian Reservation in Arizona. If you do not want the clock to adjust itself automatically according to Daylight Saving Time, you can disable it by pressing and holding the TUNE+ (DST start date) or TUNE- (DST end date) button for 5 secs, the display will show DST start or end date accordingly, which means the auto Daylight Saving Time has been enabled (`On’ by default). Press either the TUNE+ or TUNE- button to toggle between ‘OFF’ or ‘On’ DST setting. Leave it idle for a few seconds to save your DST setting and resume to clock mode.

Adjusting The Wake Up Time and Alarm Week Mode IMPORTANT:Alarm settings can only be adjusted in Standby mode.
you may use one alarm for weekdays and the other for weekend wake up times.The procedure for adjusting the wake up times is the same for both Alarm1and Alarm2. ·Press and hold either the AL1 or AL2 button until the display blinks and changes from
the current time to the Alarm 1 or Alarm 2 wake up time. ·Release the AL1(AL2) button,press the TUNE- or TUNE+ button to adjust Hour,press the AL1(AL2) again to confirm, then the Minutes will blink, press TUNE- or TUNE+ to adjust Minutes.
·Press the AL1(AL2) button again,Alarm Week Mode will blink .Press the TUNE- or TUNE+ button repeatedly to select your desired Alarm Week Mode:d1-7,d1-5 or d6-7 ·Press the AL1(AL2) button again to store the alarm setting and resume to clock mode.

d1-7 d1-5

week

(1 or 2 )
Press the AL1 (AL2) button repeatedly to turn the 1 or 2 lndicator On.
2) Press and hold the AL1 (AL2) button until the display blinks and changes from the current time to the Alarm1 or Alarm2 wake up time.
3) Release the AL1 (AL2) button, press the TUNE- or TUNE+ button to adjust Hour, press the AL1(AL2) again to confirm, then the Minutes will blink, press TUNE- or TUNE+ to adjust Minutes. 4) Press the AL1 (AL2) button again, press the VOL+ or VOL- button to adjust alarm
volume (V01~V16) that will come on at wake up time. 5) Press the AL1 (AL2) button again, press the TUNE- or TUNE+ button to select
alarm week mode (d1-7 everyday, d1-5 weekdays or d6-7 weekends only), if necessary.
6) Press the AL1 (AL2) button to save the alarm settings. 7) Press the AL1 (AL2) button repeatedly, if necessary, until 1(2) indicator glows
(alarm activated)
8 reaches

ON/OFF

AL1

Week 10

(1 or 2 )

d6-7 it Press

Week
week Week

pressandholdtheAL1 time.Press
press
Press TUNE- or TUNE+ to select week mode.

Week

Alarm Week Mode

and hold

flashing

Press the AL1 (AL2) setting

button to display the Alarm Week Mode currently selected.

Press

1

2

Note: Wake-to-buzzer alarm volume is fixed, cannot be adjusted.

band

the BAND BAND
VOL+

VOL-

TUNE- or TUNE+ TUNE- or TUNE+

press the

rear

Saturaday

2022 CLOCK SET

STO. MEM.

TUNE- or TUNE+ STO.

steps below:

TUNE- or TUNE+

briefly ON/OFF button once.

previous page to Follow the instructions on sections Setting the Year/Date/Time to set the clock to the correct year,date and time
Press the CLOCK SET button repeatedly to check the year,date and time. Make final adjustment if necessary.
3 to 5
7

CKS1500

a long wire located at the back.Extend this antenna wire fully and orient it for better FM reception.

CKS1500-20230320-01

Printed in China

References

• Celebrating 100 years of Consumer Electronics | Emerson Radio
• Documents - Owner's Manuals | Emerson Radio

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>