one LIGHT 7884 LED Light Strip Instruction Manual
- June 10, 2024
- one LIGHT
Table of Contents
one LIGHT 7884 LED Light Strip
A. CUT:
The LED strip can be cut every 2,5cm at the clearly marked positions. Cut
carefully at the desired length by using a sharp pair of scissors.
B. CONNECT:
To connect together two pieces of LED strips or a power supply cable to the
LED strip, use a soldering iron to solder the two pieces together.
C. INSTALLATION:
Remove the 3M double face adhesive tape from the LED strip gradually during
installation and fix into the required position.
INSTALLATION
Warnings:
- The mounting surface must be clean, dry and free from dust or grease.
- Make sure that the product is installed properly before connecting to electricity.
- Do not bend, fold or twist the LED strip.
- Do not bend to install in corners.
- Do not put excessive pressure on surface of LED strip.
- Do not cover LED strip with any materials.
- Do not install in ambient temperatures below -10°C or exceeding 45°C.
- Always handle the LED strip with care.
- he LED strip should not be exposed to direct sunlight.
- LED strips with different batch numbers may have slight variations in colour consistency (CCT ±150K).
- Maintenance and installation should only be carried out by a professional electrician.
Tools Needed:
- Requires 24V DC driver.
- Supplied in 5m roll with double face adhesive tape.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>