Hasbro NERF PRO GELFire MRBeast User Manual
- June 10, 2024
- Hasbro
Table of Contents
Hasbro NERF PRO GELFire MRBeast
Product Information
The product is a NERF GelFire blaster with an extendable stock, removable barrel, and hopper. It comes with a rechargeable 7.4V 500mAh LiPo battery that can be charged using a USB-A to USB-C charging cable. The blaster has a trigger lock for safety, and it uses official NERF GelFire Rounds that should be hydrated with clean tap water before use. The blaster is not a toy and should only be used by individuals aged 14 and up.
Product Usage Instructions
Customize the Barrel To remove the barrel, follow these steps:
- Press both barrel release buttons located on either side of the blaster.
- Slide the barrel out of the blaster.
To attach the barrel, follow these steps:
- Align the barrel with the blaster’s barrel opening.
- Push the barrel into the opening until it clicks into place.
Extend/Retract the Stock To extend the stock, follow these steps:
- Press both stock release buttons located on either side of the blaster.
- Pull the stock out until it locks into place.
To retract the stock, follow these steps:
- Press both stock release buttons located on either side of the blaster.
- Push the stock in until it locks into place.
Charging the Battery To charge the battery, follow these steps:
- Remove the battery from the blaster by squeezing the tabs and sliding the battery out.
- Using a USB-A to USB-C charging cable, insert the USB-C end into the battery charger port.
- Attach the cable to a USB-A wall charger (not included).
- It takes approximately 2 hours to fully charge the battery.
- Store the battery outside of or separate from the blaster.
Hydrating Rounds To hydrate the rounds, follow these steps:
- Open one packet of rounds and pour them into a container of clean tap water.
- Use at least 0.5 gallon/2 liters of water per 5,000 rounds.
- Allow rounds to remain in the water for about 3-4 hours to be fully hydrated.
Attaching the Hopper To attach the hopper, follow these steps:
- Remove the cap from the hopper and fill it with hydrated rounds.
- Drain all water from the hopper.
- Holding the blaster upside down, twist the hopper onto the blaster with a 1/4 turn to lock it in place.
- Make sure the hopper is securely attached and turn the blaster right side up.
Round and Blaster Storage To store hydrated rounds, discard any unused rounds. To store the blaster, follow these steps:
- Store the battery outside of or separate from the blaster.
- Make sure the trigger lock is in the locked position when storing the blaster.
- Clean the blaster of any Nerf Pro Gelfire round residue that remains in the hopper feed or the barrel before storage.
BARREL
STOCK
CHARGING BATTERY
REMOVE BATTERY Squeeze tabs and slide battery out of the blaster.
CHARGE BATTERY
- Using a USB-A to USB-C
- charging cable, insert the USB-C end into the battery charger port.
- Attach the cable to
- a USB-A wall charger (not included).
- It takes approximately 2 hours to fully charge the battery.
- Light is steady when charging.
- The light shuts off when the battery is fully charged.
- Flashing light: Charging issue. Unplug and replug the charging cable, and try charging again.
Store the battery outside of / separate from the blaster. For peak performance, fully charge the battery before each battle. Recharge when the rate of fire noticeably declines.
INSERT BATTERY
Includes rechargeable 7.4V 500mAh LiPo battery. Replaceable.
IMPORTANT: RECHARGEABLE BATTERY INFORMATION Retain this information for
future reference. Batteries should be replaced by an adult.
WARNING : Risk of fire, explosion, and burns. Do not disassemble, crush,
heat above 45 °C (113 °F), or incinerate. Dispose of this battery according to
your local recycling or waste regulations – never disassemble it. Do not use
the item near a heat source such as a fire or heater.
CAUTION: Risk of fire and burns. Do not open, crush, heat above 45˚C, or
incinerate. Follow the manufacturer’s instructions.
WARNING: Use only with the device provided. Chargers used with the
product are to be regularly examined for damage to the cord, plug, enclosure
and other parts, and, in the event of such damage, the product must not be
used with this charger until the damage has been repaired.
NOTE: The battery terminals are not to be short-circuited.
HYDRATE ROUNDS
Open 1 packet and pour rounds into a container of clean tap water. It is recommended to use at least 0.5 gallon/2 liters of water per 5,000 rounds. If you want to hydrate only some of the rounds in a packet and save some rounds for later, use the same amount of water. More water than recommended will not impact hydration: It is not possible to overhydrate the rounds or grow them too large to function in the blaster. Make sure rounds are fully submerged in water.
ATTACH HOPPER
Remove cap from hopper and hold it with opening facing up Fill hopper with hydrated rounds. Drain ALL water from hopper. Holding blaster upside down, twist the hopper onto blaster with a 1/4 turn to lock it in place. Make sure hopper is securely attached. Turn blaster right side up.
FIRE
Wear the included protective eyewear. when you or anyone else nearby is using a Nerf Pro Gelfire blaster.
Turn the selector to the desired mode:
Semi-auto Fires a round per trigger pull.
Füll-auto:
Fires continuously while the trigger is depressed.
Selector Light Off
NOTE: Always turn selector to OFF when not in use.
BLASTER STORAGE
- Store the battery outside of / separate from the blaster.
- Make sure trigger lock is in locked position when storing the blaster.
- Prior to storage, clean the blaster of any Nerf Pro Gelfire round residue that remains in the hopper feed or the barrel. Use a long soft and clean item, such as a cotton swab, to clear debris. Clean only with a damp cloth or a soft, clean, dry item
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy, and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. CAN ICES-3 (B)/NMB-3(B)
TO AVOID EYE INJURY:
WARNING : Do not aim at eyes or face. Use of eyewear is always required
for players and people within range. Use only official NERF GelFire Rounds.
Use only clean tap water to hydrate rounds. Do not freeze or modify rounds. Do
not modify the blaster. The impact from rounds may cause temporary marks on
the skin. Ages 14 and up. This is not a toy. Read instructions before use for
important safety information.
WARNING : COMPLY WITH ALL LAWS. Check to ensure the use and possession of
this product is allowed where you are intending to use it, as using,
displaying, transporting, or carrying this product may be prohibited by law or
regulation in certain locations, such as schools, airports, government
property, and high-density areas. Do not aim or blast at bystanders, animals,
moving vehicles, or others’ property. Do not alter this product to make it
look like a firearm. Such alteration is dangerous and could be a crime and/or
create confusion by law enforcement or others that it is a firearm.
DO NOT EAT. KEEP AWAY FROM PETS. ROUNDS MAY STAIN.
- MRBEAST and the Beast Logo are trademarks of Beast Holdings, LLC, Greenville, NC 27858
- NERF and HASBRO and all related trademarks and logos are trademarks of Hasbro, Inc. © 2023 Hasbro.
- Hasbro, Pawtucket, RI 02861-1059 USA. US TEL. 1-800-255-5516. Patent: patent.hasbro.com
- F8672: PN00082227
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>