Govee B6062A01 Glide Wi-Fi LED RGBIC Wall Light User Guide
- June 10, 2024
- Govee
Table of Contents
Govee Glide Wall Light
Quick Start Guide
B6062A01 Glide Wi-Fi LED RGBIC Wall Light
To Watch The Installation Video Tutorial
- Search “Govee Glide Wall Light” on Amazon or YouTube.
Caution
- Do not power on until you have assembled all segments.
- This product s ideally used on smooth surfaces (e.g. glass, wood, etc); not suitable for uneven, bumpy or wet surfaces (e.g. brick, stucco, etc).
- Keep the product away from water. If you need to clean t, please use a dry rag.
- Clean and ensure the surface is totally dry before sticking the product on.
In the Box
- 8 Segments (30cm each
- 2 Corner Piece
- 1 Control Box and Input
- 1 Power Adapter
Before Installation
Step1
Assemble the segments with the desired layout on a flat surface.
Step 2
Connect the input to the end segment/corner piece. Then connect the control
box to the power adapter.
Step 3
Power on to check each segment is working. Next, power off, isassemble the
segments, and disconnect the control box.
Step 4
Plan the appropriate installation location in advance. Determine the position
of the outlet, itis recommended to place the control box and adapter close to
the outlet.
Installation Steps
Step 1
Install the segments from the side farthest away from the adapter. When
installing, remove the protective film and push each segment firmly on the
wall for at least 30 seconds.
Step 2
After assembling all the segments, connect the input at the end of the control
box wire to the end segment and finally to the power adapter.
To Disassemble
Pull to detach the segments and then remove the adhesive tape from the
wall.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>