HARMAN 700 Citation Multibeam User Guide

HARMAN 700 Citation Multibeam User Guide

1) APP

The Google Assistant setup

App Store
Google Play

All product features will be set up.

AirPlay setup

For AirPlay only users, skip the Google Home app; on your iOS device, go to Settings > Wi-Fi and select “Citation MultiBeam 700” under SET UP NEW AIRPLAY SPEAKER … Follow the onscreen instructions to complete setup

Google Assistant and Chromecast built-in™ will require additional set up with the Google Home app.

2) PRODUCT TOUR

Top & Front

Back

3) CONTROL / INFORMATION ON TOUCH SCREEN

4) CONNECT TO YOUR TV

5) WALL MOUNT THE CITATION MULTIBEAM 700

Use tape to stick the wall-mounted paper guide on the wall, push a pen tip through the center of each mounting hole to mark the wall-mounted bracket location and remove the paper.

Screw the wall mount brackets on the pen mark; screw the threaded mounting post into the back of the Citation MultiBeam 700, then hook the Citation MultiBeam 700 on the wall.

6) GET STARTED

Add Citation MultiBeam 700 to your home Wi-Fi network:

Download and run the Google Home app on a phone or tablet.
Follow the instructions on the touch screen and Google Home app to finish the setup.

• Enable Bluetooth (iPhone / iPad).

7) SET UP MULTIBEAM™ SURROUND SOUND

Automatic MultiBeam Calibration (AMC) will optimize the soundbar sound settings for a better surround sound experience.

8) CHROMECAST BUILT-IN™

Step 1: Open Chromecast supported app.
Step 2: Play Music.
Step 3: Tap the cast icon and select “Citation MultiBeam 700”.
e.g.
Spotify
Pandora
TuneIn
Deezer
Google Play Music

• Device can support multi-room control provided by Chromecast built-in, more details you can refer to Google Home app.

9) AirPlay

Step 1 : On an iOS device, enter the Control Center.
Step 2 : Tap to select “Citation MultiBeam 700” as speaker.
Step 3 : Start audio streaming from an app

10) GOOGLE ASSISTANT

11) OWNER’S MANUAL

Download the full owner’s manual fromharmankardon.com

12) SPECIFICATIONS

• Model Name: CITATION MULTIBEAM 700
• Power supply: 100 – 240 V ~ 50 / 60Hz
• Output power: 210 W RMS
• Bluetooth version: 5.1
• Bluetooth transmitter frequency range: 2402 – 2480 MHz
• Bluetooth transmitter power: <10 dBm (EIRP)
• Bluetooth transmitter modulation: GFSK, π/4 DQPSK, 8DPSK
• Wireless network: 802.11a/b/g/n/ac (2.4GHz/5GHz)
• 2.4G Wi-Fi transmitter frequency range: 2412 – 2472 MHz (2.4GHz ISM Band, USA 11 Channels, Europe and others 13 Channels)
• 2.4G Wi-Fi transmitter power: <20 dBm (EIRP)
• 2.4G Wi-Fi modulation: DBPSK, DQPSK, CCK, QPSK, BPSK,16QAM, 64QAM
• 5G WISA transmitter power: < 18 dBm (EIRP)
• 5G WISA modulation: OFDM, BPSK, QPSK, 16QAM
• 5G WISA transmitter frequency range: 5.15 – 5.35 GHz, 5.470 – 5.725GHz, 5.725 – 5.825 GHz
• 5G Wi-Fi transmitter power: < 23 dBm (EIRP)
• 5G Wi-Fi modulation: QPSK, BPSK, 16QAM, 64QAM, 256QAM
• 5G Wi-Fi transmitter frequency range: 5.15 – 5.35GHz, 5.470 – 5.725GHz, 5.725 – 5.825GHz

Note : CITATION MULTIBEAM 700 is in compliance with European Commission Regulation (EC) No 1275/2008 and (EU) No 801/2013.

Power consumption

• Off Mode: N/A
• Standby: N/A
• Network Standby*: 2.0 Watts
  Time to networked standby: 18 minutes
• Networked standby: in the condition of any wireless connection of the device is activated, if no provide any audio or video signal to the device, it will automatically into networked standby mode in 18 minutes. Any audio or video recover will bring device from standby to operation mode.

This device complies with Part 15 of the FCC rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3 (B) / NMB-3 (B).

IC Caution:

User should also be advised that:

(i) the device for operation in the band 5150 – 5250 MHz is only for indoor use to reduce the potential for harmful interference to cochannel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in the bands 5250 – 5350 MHz and 5470 – 5725 MHz shall comply with the e.i.r.p.
limit: and
(iii) the maximum antenna gain permitted for devices in the band 5725- 5825 MHz shall comply with the e.i.r.p. limits specified for point-to point and non point-to-point operation as appropriate.
(iv) Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250 – 5350 MHz and 5650 – 5850 MHz and that these radars could cause interference and/or damage to LE- LAN devices.

Warning : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can cause
interference with and/or damage this device. No configuration controls are provided for this wireless equipment allowing any change
in the frequency of operations outside the FCC grant of authorization for US operation according to Part 15.407 of the FCC rules.
FCC/IC Radiation Exposure Statement: This equipment complies with FCC/IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

Use Restriction: This device is restricted to indoor use when operating in the 5150 to 5350 MHz frequency range in following countries:

This product contains open source software. For your convenience, the source code and relevant build instruction for software licensed under the GPL is available at http//www.harmankardon.com/opensource.
You may also obtain this information by contacting us at OpenSourceSupport@Harman.com

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.

The Wi-Fi CERTIFIED™ Logo is a certification mark of the Wi-Fi Alliance®.

Manufactured under license from Dolby Laboratories. Dolby, Dolby Audio, and the double-D symbol are trademarks of Dolby Laboratories.

The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

Chromecast built- in, Google Play and the Google Play logo are trademarks of Google LLC.
Chromecast built-in may require subscription(s). The Google Assistant requires an internet connection and is not available in certain countries and languages. Availability and performance of certain features and services are device, service and network-dependent and may not be available in all areas.
Controlling certain devices in your home requires compatible smart devices. Subscriptions for services and applications may be required and additional terms, conditions and/or charges may apply

Apple®, AirPlay®, iPad®, iPad Air®, iPad Pro®, and iPhone® are trademarks of Apple Inc., registered in the U.S. and other countries.
Use of the Works with Apple badge means that an accessory has been designed to work specifically with the technology identified in the badge and has been certified by the developer to meet Apple performance standards.
To control this AirPlay 2–enabled speaker, iOS 11.4 or later is required.

CH_HK_Citation_Multibeam 700_QSG_Global_CR_V16

References

• German market leader for CRM in SMEs - CAS Software
• Harman Kardon
• Anatel — Agência Nacional de Telecomunicações
• Microsoft Cortana SDK for Harman Open Source Components

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>