Adapters AX3010 WiFi 6 Wireless USB Adapter Installation Guide
- June 10, 2024
- Adapters
Table of Contents
Adapters AX3010 WiFi 6 Wireless USB Adapter
Please read the manual before use (If you have any questions, please consult customer service)
Hardware connection
Please insert the usb adapter directly into the computer’s USB port.
Note: When using the desktop PC, it is recommended to connect the rear
interface of the computer chassis,the effect is better!
(Most of the desktop computer’s front USB interface is underpowered or
unavailable)
Driver Installation
Applicable system: Windows 7,10,11
- Please use the U disk to install the driver before use, the driver name is “Setup.exe” and follow the direction to finish the installation
- After the installation is completed. click to restart the computer
- After restarting the computer, connect to WiFi.
Notice:
- The U disk cannot be recognized, or the file is damaged Please log in to the website to get the installation package, URL https://www.dropbox.com/s/k6n1ehtjmqiz6ea/X.rar?dl=0
- If there is a computer firewall,or a virus is displayed,the anti-virus software does not recognize the driver software Please turn off the antivirus software first and then start the nstaller
- If it cannot be used after installation1) Replace the USB port, or use the USB port on the back of the main computer2) After deleting all network card drivers, reinstall the drivers
Wireless Connection
- Click on the Wi-Fi icon on the taskbar;
- Select SSID connection.
FCC
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
The frequency stability of all transmission frequencies of U-NII-1 and U-NII -3 meets the 47 CFR FCC Part15.407(g) requirements, and the manufacturer states that their transmissions remain within the U-NII-1 and U-NII -3 bands.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>