BLACK DECKER BD1007 Ratchet Straps Instruction Manual
- June 10, 2024
- Black Decker
Table of Contents
BD1007 Ratchet Straps
Instruction Manual
BD1007 Ratchet Straps
WARNING: READ AND UNDERSTAND ALL INSTRUCTIONS AND FULLY COMPLY WITH ALL
WARNINGS.
FAILURE TO DO SO MAY RESULT IN DAMAGE TO THIS PRODUCT, PERSONAL PROPERTY
AND/OR PERSONAL INJURY.
- With ratchet closed, thread webbing from the center spool through the ratchet reel.
- Pull webbing through, removing the slack.
- Release the ratchet by lifting the release bar. To tighten, raise and lower ratchet handle; do not overtighten. (Make sure to have a minimum of 2 full wraps of webbing around the reel.)
- Keep ratchet in closed position to lock.
TO RELEASE:
- To unlock, pull the release bar until the ratchet is completely flat and open
- Grab webbing and pull to release.
WARNING:
- ANSI approved eye protection to be worn at all times during use.
- DO NOT use strap that has fraying, wear, broken or worn stitching, tears, cuts or defective hardware. If the strap is damaged DO NOT use it and discard it.
- DO NOT exceed the working load limit of the strap; taking into account the strap, the load, the vehicle anchor points, strap configuration and angle, etc.
- DO NOT over-tighten straps.
- NEVER stand in direct path of a tension loaded strap.
- Maintain and store straps properly. Straps should be protected from mechanical, chemical and environmental damage.
- ALWAYS protect straps in contact with edges, corners, protrusions, or abrasive surfaces with materials of suficient strength, thickness and construction to prevent damage.
- Manufacturer is not liable for accidents caused by material deterioration or improper use.
- For more information on the manufacturer’s warranty, visit www.blackanddeckerstraps.com , or contact BCS at 877-257-8727 or email info@blackanddeckerstraps.com
The warranty of this product is covered by BCS International.
WARNING: CANCER AND REPRODUCTIVE HARM
– www.P65Warnings.ca.gov
©2022 Black & Decker, Inc.
Black & Decker and the Black & Decker Logo are trademarks of Stanley Black &
Decker, Inc. or one of its affiliates, and are used under license.
Products are distributed by: BCS International
Made in China
WORK STRENGTH
833 LB. / 377.8 KG.
BREAK STRENGTH
2500 LB. / 1134 KG.
www.BLACKANDDECKER.com
www.BLACKANDDECKERSTRAPS.com
Documents / Resources
|
BLACK DECKER BD1007 Ratchet
Straps
[pdf] Instruction Manual
BD1007, BDX1007, BD1007 Ratchet Straps, Ratchet Straps, Straps
---|---
References
- Home | BLACK+DECKER
- BLACK+DECKER® Straps: Automotive Specialty and Cargo Solutions | BLACK+DECKER® Straps
- P65Warnings.ca.gov
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>