workwell TECHNOLOGIES JL2500 Cloud Time Clock User Manual
- June 4, 2024
- workwell TECHNOLOGIES
Table of Contents
workwell TECHNOLOGIES JL2500 Cloud Time Clock
Description
uAttend time clocks work in conjunction with the online cloud account and allow customers to automate their time and attendance management. Employees use the time clocks to record their punch times which are then sent to the online account, while the uAttend online account gives customers the ability to streamline their processes using the system’s automated time card calculation engine.+
Time Clock Features:
- Allows employees to authenticate for time and attendance by punching by scanning a fingerprint, RFID of entering a unique personal identification number(PIN) .
Allows employees to perform In/Out, Break/Lunch, Department transfer and job punch on the time clock.
Connects to the internet using wifi or Ethernet.
- Captures and sends real-time punches to the uAttend online account.
The time clock works in conjunction with the uAttend online account to track time by pay period, automate rules, and run advanced calculations for exporting time data to payroll systems.
Linux Device Function Test Illustration
Note: The function test mainly tests whether led, fingerprint module, speaker,
wifi, and Ethernet work properly. The pre-installed application TestForMost
will complete the test, and observe the working status of the device and
application to determine whether the corresponding module works properly.
Click test app to start the test on the desktop:
- Application button description (blue font is button description)
Wifi Test-Test Wifi Functions
Click the button “WiFi test” to enter the WiFi test interface, click the wifi on/off button, and open WiFi to search the nearby WiFi, that is, WiFi works normally, and if cannot be opened,or the nearby WiFi can not be searched, which is abnormal.
Ethernet Test-Test Ethernet Module
Click the button “Ethernet Test” to enter the Ethernet test interface, insert
the network cable from the network cable interface at the rear of the device,
click the switch to turn on the Ethernet, and the IP address can be obtained
normally, and the network can be used withoutWiFi connection which is normal.
Fingerprint Head Test-Test Fingerprint Module
Click the”fingerprint device test”button to enter the fingerprint head test interface. Press the fingerprint module position with your finger to check whether the device can read the user’s fingerprint normally.
RFID Test-Test RFID
Click the button “RFID” to enter the RFID test interface, move the card with
ID information nearthe coil position,and check whether the device can read the
card ID information normally.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>