AED MULTI12 12 Inch Two-Way Full Range Active Speaker and Wedge Monitor User Manual
- June 11, 2024
- AED
Table of Contents
AED MULTI12 12 Inch Two-Way Full Range Active Speaker and Wedge Monitor
User Manual
INTRODUCTION
The MULTI12 is a multipurpose 12“ two-way self-powered speaker with built-in DSP. The cabinet is made of robust engineering Polymers which results in a lower weight, and a high power. The MULTI12 has an improved sound quality due to its high quality European branded speaker components. You can use the MULTI12 as live PA speaker, for DJ sets, with or without sub, but also as a wedge monitor, DJ monitor and for sound reinforcement in pub’s, clubs, small theaters, churches and many more. This highly versatile product can be
used in many ways.
With a 12” low-frequency woofer and a 1” high-frequency compression driver with a titanium diaphragm, the MULTI12 is a 2-way full-range active speaker that can be deployed in multiple applications. Its characteristics include big dynamic, high sensitivity, clear MF and HF with a powerful LF.
The MULTI12 design takes care of combining the horn with the cabinet. Due to its rigging points and mounting holes, the rigging possibilities are endless. Pair your Bluetooth device by only pressing a button and play your favourite music in an instant. Connect your instrument or microphone by using a jack or XLR input on the back panel of the speaker. The 2-way XLR/TRS input mode ensures ease of use.
With the all-weather tote that also can used as rain cover, no weather condition is too rough to fulfil the job that has to be done. The MULTI12 is an all-round 12 inch loudspeaker that stand its ground and will make sure you will get your job done.
DISCLAIMERS
AED Audio, AED DISTRIBUTION SA, with registered office at Bedrijvenpark De Veert 13/4, 2830 Willebroek (Belgium), or any of its affiliates, does not accept any liability for material damage, including damage to the Product, or personal injury caused by non-observance by the user of the safety instructions in the Manual or the applicable laws. As such AED Audio shall among others not be liable for any damage or injury if the Product is used contrary to or for purposes other than its intended use, is installed, used, maintained or repaired negligently or contrary to the instructions mentioned in theManual or on the Product, when the Product is modified and when the safety devices and features of the Product are disregarded or overridden.
INTENDED USE
This system is intended for use by trained personnel for professional applications. The Product is not intended to be used by minors. Any use, regardless whether or not under the supervision of an adult, is at own risk.
GENERAL SAFETY INFORMATION AND INSTRUCTIONS
For your own safety, please read this instruction manual carefully before turning on the product for the first time. For your own safety, please read the safety instructions included with the product.
WARNINGS
Always take note of any information marked with the CAUTION or WARNING symbol.
CAUTION: The signal word
WARNING points out the potential risk of serious injury.
WARNING: The signal word CAUTION points out the potential risk of
slight injury. The CAUTION symbol is used to draw attention to
circumstances which could cause the machine to become damaged.
SAFETY FEATURES & DEVICES OF THE PRODUCT
The pictograms, warnings and instructions attached to the Product are part of its safety features. They must not be covered or removed and must be present and legible during the entire use of the Product. Immediately replace or repair missing, damaged or illegible pictograms, warnings and instructions.
The device can only run with 240V voltage, 50/60 Hz power, don’t connect to
any other wrong power source.
Safety I class device, need to be earth connected.
Keep this device away from
children and unauthorized users, the manufacturer will not take responsibility
for the damage due to any disregard of the information provided in this manual
and wrong operation.
Don’t put or install the
device on a surface that subject to vibration or bumps.
MODIFICATION
Under no circumstances any modification of the Product may be done by any person other than AED Audio personnel.
SYSTEM COMPONENTS
GENERAL CHARACTERISTICS AND TECHNICAL SPECIFICATIONS
TECHNICAL DATA
| Frequency response (-3dB) | 47 Hz to 18 kHz |
|---|---|
| Max SPL @1m | 117 dB / 123 dB peak |
| HF Dispersion | 90° x 60° |
| Compression driver | 1x 1” HF |
| Woofer | 1x 12” LF |
| Input signal | 100 Hz HP with sub, Mixer in/out, Stereo/Mono, 3.5mm AUX in, |
Bluetooth streaming
Input connectors| 2x XLR, 2x 1/4”, 1/8”, Bluetooth and Main in (XLR)
Total power| 500W program – 1.000W peak
Power connector| TrueCon
Cooling| Speed controlled fan
Voltage range| 110V/230V AC, 50Hz/60Hz
Cabinet/Case material| Polypropylene cabinet, ABS baffle, metal grille
Handles| 2x Plastic handles (1x side + 1x back)
Grille| Powder coated steel with grille cloth
Color| Black
Dimensions (HxWxD)| 595 x 345 x 365 mm – 23.4 x 13.6 x 14.4 in
Package dimensions (HxWxD| 655 x 436 x 420 mm – 25.8 x 17.2 x 16.5 in
Net weight| 15,6 kg – 34.4 lb
Gross weight| 17,6 kg – 38.8 lb
3 performance modes| Concert – Club – Monito
Certification| CE – UKCA – cETL
DIMENSIONS DRAWING
CONNECTIVITY
PANEL IDENTIFIERS
- Gain adjust
- Master volume
- Line / Instrument input – Mono 1/4 TRS – Line / Instrument input – Mono 1/4 TRS
- Stereo / Aux In – Stereo 3.5mm
- Main In – Mono XLR
- Mic In – Mono XLR –
- Mic In – Mono XLR
- Bluetooth® pairing CONNECTIVITY PANEL IDENTIFIERS
- Stereo / Mono switcher
- Mode selector (concert / club / monitor)
- Sub / No sub –
- Mixer enable
- Link Thru – Mono XLR
- Scan QR code for more information
- AC Input Power Con
- Power switch
CONNECTION CHART
| 1 | Keyboard or other instrument input (Line level) | Mono TRS |
|---|---|---|
| 2 | Microphone input | XLR |
| Keyboard / guitar amplifier or other instrument input (Line level) | Mono TRS | |
| 4 | Microphone or instrument via DI-box) input | XLR |
| 5 | Smartphone or other device auxiliary input | Stereo 3.5 mm |
| 6 | Main input | XLR |
| 7 | Wireless connection | Bluetooth® |
| 8 | Balanced mono output | XLR |
TRANSPORTATION, HANDLING AND COMMISSIONING
TRANSPORTATION
Keep the product dry and the temperature between 0°C and 30°C to avoid damage to the speaker. Please always handle with care.
REMOVE THE SHIPPING ASSEMBLY
Before unpacking the fixture, please make sure that the packaging is in good condition and that following items will be found in the box:
- 1x MULTI12
- 1x Safety instructions
Remove the tape from the box and open the box. Take the unit out and remove the plastic foil around the unit. Make a visual inspection of the unit. Please check condition of units while unpacking, if any damages occur, the unit must be repaired/replaced before it can be used. Please contact your local distributor for service. If units are damaged and still used, AED Audio cannot be held liable for any risk/danger or occurrence given by these damaged units.
INSTALLATION
There are specific regulations like BGV C1 (old VBG 70) or country related regulations which need to attend during the installation. The installation has to be handled by skilled persons only! Suspension device has to be built and calculated in order to handle up to 10 times its specific load limit over a time of one hour without permanent or harmful deformation. Installation has to be done with a separate, independent suspension device like a safety chain. Trespassing the danger zone below the installation during the assembling is prohibited. Installer has to take care of all safety and machinery installations are approved by authorized persons before first operation or after changes before restarting. Installer has to take care of all safety and machinery installations are approved by skilled persons at least once a year. Installer has to take care of all safety and machinery installations are approved by authorized persons every four years during the acceptance inspection. Spotlight should ideally installed outside peoples lounge area.
ATTENTION
Installation overhead needs a high level of experience. This includes (but is not just limited to) calculation and definition of load capacity, used installation material and regular safety inspections of used material and the fixture itself. Never try to do the installation by yourself if you are not qualified, instead you have to instruct a skilled installer. Inappropriate installations can cause injuries and/or damage of property.
CAUTION: Mounting place must be
sufficient stable and be able to support a weight of 10 times of the unit’s
weight.
CAUTION: Assure the specified
safety distances to flammable material.
MAINTENANCE
Operation only allowed to qualified person, damages due to unprofessional operation or remove of any parts inside will not be considered in warranty service. There are no serviceable parts inside the device or package, service only leaves to authorized dealers.
TROUBLESHOOTING AND REPAIR
FAULT LIST
| PROBLEM | SOLUTION |
|---|---|
| Bluetooth® doens’t connect | Check if your telephone Bluetooth® function is |
active
The unit will not turn on| Try a different power socket or check the power on
switch (more info: on page 5). If this doesn’t work, contact your repair
center.
There is no bass in my music| Check button number 12 (Sub / No Sub) (more
info: page 5)
The unit sounds distorted| Check the gain adjust settings (more info: page 5)
My microphone is connected but I have no sound| no sound Check the Mixer
enable button (more info: page 5)
I have connected with Bluetooth® but I don’t hear anything| Check if your
music on your mobile device is playing
REPAIR
If the Product is damaged or malfunctions, contact the AED Audio Service Department or a AED Audio authorized distributor. Repairs by parties other than AED Audio or a AED Audio authorized distributor may not involve the use of AED Audio genuine parts and may affect the safety and functionality of the Product. For repair options or specific inquiries, please contact the AED Audio Service Department.
CONTACT DETAILS CERTIFIED REPAIR CENTER
AED Repair
Bedrijvenpark De Veert 11, 2830 Willebroek – Belgium
info.repair@aedgroup.com
aedgroup.com/en/services/aed-repair
All rights reserved. No part of this manual may be copied or published by means of printing, photocopying, microfilm or otherwise without the prior written consent of the manufacturer. This restriction also applies to the corresponding drawings.
The information given in this manual has been collected for the general convenience of our customers. It has been based on general data pertaining to construction material properties and working methods known to us at the time of issue of the manual and is therefore subject at any time to change or amendment, and the right to change or amend is hereby expressly reserved. The instructions in this manual only serve as a guideline for installation, use, maintenance and repair of the product mentioned on the cover page of this document. This manual is to be usd for the standard model of the product of the type given on the cover page. Thus the manufacturer cannot be held responsible for any damage resulting from the application of this manual to any other product.
This manual has been written with great care. However, the manufacturer cannot be held responsible, either for any errors occurring in this manual or their consequences.
AED Audio – MULTI12 – User manual 9
WWW.AEDAUDIO.COM
AEDaudio
aed_audio
AED Distribution NV, Bedrijvenpark de Veert 13/004, 2830 Wille broek, Belgium
