Invitop Demi pro Air Purifier and Humidifier Instruction Manual
- June 11, 2024
- Invitop
Table of Contents
Invitop Demi pro Air Purifier and Humidifier
Thank you very much for using our products.
Please read the user manual carefully before use,and keep it for future
reference.
TECHNICAL REQUIREMENTS
- Color box &paper card: material and size should be according to document requirements, the size of the finished product deviation within 2-3mm requirements;
- Carton: material and size should be according to document requirements, the size of the finished product deviation within plus 5-10mm requirements;
- PE foam: the bonding place of PE foam should be smooth, the glue should be even, and the size of the finished product deviation within 2-3mm requirements;
- Manual, warranty card, label, album and other printing materials must meet the inspection requirements of the quality department;
Details of all packaging materials can be compared with the Inspection guide for incoming materials of packaging cartons – document No. : YWT-WI-PZ-15, YWT-WI-PZ-17,YWT-WI-PZ-21
- The printed contents, patterns, and fonts shall meet the requirements of drawings or sealed samples and the patterns shall be clear, and full, no decolorization and obvious overflow edge; and the position shall be accurate, horizontal deflection is not allowed to exceed 5mm, pattern shall be consistent in color, have good ink adhesion, and not decolorize with fingers;
- Packing materials must have protective measures and are not allowed to damage their outer surface due to packaging and transportation.
- Products need to comply with the six hazardous substance requirements specified by the EU Rohs
IMPORTANT
Before using, please read this user manual carefully and keep it for future reference.
Danger warning
- To avoid get electric shock and fire, do not allow water, liquid or any flammable detergent to get into or clean the product.
- Do not spray insecticide, perfume or other flammable spray around the products.
Safety warning
- Before connecting the power supply, please check whether the voltage of the product is consistent with the local power supply voltage.
- If the power cable is damaged, it must be replaced by an electrical technician or professional personnel to avoid danger. Do not use when the plug,or mains cord or the product is
- damaged Do not block the air inlet and outlet, for example, do not place
- objects on or in front of the air outlet. Do not insert external matter into the product through the air
- inlet. This product should not be used by persons (including children)
- with physical disabilities, mental disabilities, or lack of relevant experience and skills, unless they are given instructions by the person responsible for their safety.Do not allow children to play with the product or to clean and maintain the product unsupervised.
- Do not allow children to clean the product while unsupervised.
Notice
- This product is not a substitute for normal ventilation, daily vacuuming or cooking range hoods.
- The plug of the product may become very hot If the power socket connected to the product is not in good contact. Ensure
- to connect the product to power socket properly.
- Do not place anything on the product. Ensure the product is used in condition of a stable and horizontal surface.
- Please leave at least 30cm of space on the back and sides of the product, and at least 50cm of space above the product when using.
- Do not put the product directly under the air conditioner to prevent condensate dripping into the product.
- Before turning on the power supply, make sure that the filter and filter cover are properly installed.
- Do not use any other filters except the filters produced by Invitop.
- Burning the filter may cause irreversible human harm or endanger other lives. Do not use the filter for fuel or similar purposes.
- Do not hit the product with hard objects (especially the air outlet and inlet).
- Do not insert finger or other objects into the air outlet/inlet to prevent physical damage or trouble.
- Do not use this product when using indoor aerosol repellent or in places filled with oil, flammable gas or chemical fumes.
- Ensure the appliance is power-off and unplugged before cleaning for maintaining and replacing filter.
- Please unplug the product before moving it. Do not move the product by pulling the mains cord.
- When using the air purification function, do not put the water tank on the machine;
- When using the humidification function, please put the water tank on the top of the machine correctly;
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modifica- tion is made. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body
NOTE:
This equipment may generate or use radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless the
modifications are expressly approved in the instruction manual. The user could
lose the authority to operate this equipment if an unauthorized change or
modifica- tion is made. This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. This
equipment complies with R radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20 centime- ters between the radiator and your bodyThis
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- The rating information is located at the bottom of the unit.
PRODUCT OVERVIEW
Components
SPECIFICATION
INSTRUCTION
Remove filter package
Please remove the packing of the filter before using the new product. Be sure
to unplug the air purifier from the power outlet before removing/installing
the filter.
- Up side down the air purifierand turn the base counterclockwise to open the appliance.
- Remove the filter from air purifier.
- Remove the packing of filter.
- Install the filter.
- Turn the base clockwise to reset the appliance.
Power button:
Touch the power button, the machine rings, then can turn on/off the machine,
Default low speed working; Long press this button to reset the filter’s
working life.
Note:
If turn off the machine without unplugging the power plug and turn it on
again, the air purifier will be in the working state before shutdown by
default. Wind speed/WiFi composite button: The machine will ring every time
you touch the wind speed button when it is working.
Wind speed mode:
sleep – low – high gear; Long press this button to use the WiFi function; The
filter/WiFilight flashes white, after successful connection, this light will
keep light.
Light button:
In the working state, press this button to switch light mode, the default
seven color lights cycle change, press this button again to stop the light
color change, keep the color, and press this key again to turn off the light.
UV function: After turning on the machine, the UV will automatically turn
on for 2 hours and turn off after 2 hours working, turn on/off auto cycle.
Timer function: Timer need to be controlled through the APP,
respectively: 2-4-6hours.
WIFI OPERATION
- Use your mobile phone to scan the QR code below to download the “Smart Life” APP. You can also search for “smart life” in the APP store or Google Play to install the APP.
- Open the “Smart Life” app, click “register”, use your phone number or email to register the “Smart Life” account, and then log in to the App.
Add device
- Connect the mobile phone to the home wireless network, and turn on the mobile phone Bluetooth (please select 2.4GHz WiFi network).
- Open the “Smart Life” APP.
- Enter the homepage of the “Smart Life” APP. Click “+” to select to add a device, the APP will display manual addition and automatic discovery.
- Automatic discovery: When the corresponding authority is turned on, the device can be automatically discovered, and the device needs to be in the network configuration state and turned on.
- Manually add: select the name corresponding to the product, WIFI+Bluetooth mode.
Bluetooth configuration:
When confirming that the WIFI indicator of the device is flashing quickly,
click OK, and then wait for the connection. (Recommend- ed,) When
“Successfully add 1 device” appears, it means the connection has been
completed and your device will be listed in your APP list.
Hotspot configuration network:
Click on the WIFI quick connection in the upper right corner to select the
hotspot distribution network (compatibility mode), Confirm that the WIFI
indicator of the device flashes slowly, click OK, and enter your home WIFI and
WIFI password. Next, click to connect to go to the WLAN setting interface of
the phone, and then select the Wi-Fi network “SmartLife_XXXX” to connect it.
Your device will be listed in your APP list. Now, you can control your smart
device through the mobile APP anytime and anywhere (make sure your mobile
phone and smart device are connected to the network, make sure your router
name is changed to SmartLife_XXXX).
REPLACING THE FILTER
When the filter indicator keeps flashing red, it indicates the filter needs to be replaced. Please use the original filter produced by INVITOP.
Notice:
- Please clean the dust on the filter regularly. The filter should not be washed or reused.
- Ensure to turn off and unplug the appliance before replacing the filter.
- Do not use the vacuum cleaner to clean the filter.
- Please place the filter in direct sunlight regularly for sterilization.
When the air purifier has run over 2200h, the filter indicator will flash red indicating the filter needs to be replaced. After replacing a new filter, press and hold the power button for 7s to turn on the appliance again and the filter indicator will go off.
MAINTENANCE
Notice:
- Ensure the appliance is unplugged before maintenance.
- Do not immerse the air purifier into water or any liquid.
- Do not use abrasive, corrosive or flammable cleansers (such as bleach or alcohol) to clean any part of the appliance.
Cleaning:
- Ensure the appliance is power-off and unplugged.
- Remove the filter, clean the dust adsorbed on the outer surface of the filter (gently pat the filter outside the house);
- Use a soft cloth with a neutral cleanser to clean away any dust or debris from the surface of the appliance and air inlet/outlet. After the appliance and filter completely dry out, install the filter
- into the appliance then the appliance can work again.
Notice: Make sure there is no water drop into the appliance when cleaning the air outlet.
Cleaning:
- Turn off the appliance and unplug the power supply, and arrange and bundle the mains cord.
- Remove the filter, clean the dust adsorbed on the outer surface of the filter
- Clean the air inlet/outlet, wipe the body with a neutral detergent and a soft cloth.
- After the appliance is completely dried, put on a dust cover/bag and place it in a well-ventilated place not exposed to direct sunlight. If you do not use it for a long time, please turn on the appliance for
- a few minutes from time to time to ensure good performance.
FAQ
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>