JVC HAA18TB Wireless Headphones User Manual
- June 11, 2024
- JVC
Table of Contents
JVC HAA18TB Wireless Headphones
Product Information
- Model No.: HA-A18T
- Serial No.: B5A-4394-00
- IC: 12522A-A25T
- FCC ID: 2AKMBHA-A25T
- JVC is the trade name of the product
- The device complies with part 15 of the FCC rules
- The product contains a rechargeable battery that is recyclable
- The device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s)
- The device may not cause interference and must accept any interference, including interference that may cause undesired operation of the device
- Danger of explosion if user replaced battery. Do not replace battery user own self.
Product Usage Instructions
- Remove the earphones from the charging case by gently pulling them out.
- Ensure the JVC logo is on the upper side of the earphone and adjust the position to fit your ear.
- Turn on the Bluetooth of your device and pair it with the JVC HA-A18T.
- You can control the sound mode of the earphones by tapping on the touch sensor. The available sound modes are Normal, Bass, and Clear.
- Do not listen at high volume levels for long periods to prevent possible hearing damage.
- To charge the earphones, place them back into the charging case with the charging terminals aligned. The earphones will flash slowly to indicate that they are charging. It takes approximately 2 hours to fully charge the earphones and they can be used for up to 2.5 hours on a single charge.
- The product contains a rechargeable battery that is recyclable. To recycle the battery, call 1-800-8-BATTERY for information on how to recycle it.
LEGAL INFORMATION
For U.S.A.
Supplier’s Declaration of Conformity
- Model Number: HA-A18T
- Trade Name: JVC
- Responsible party: JVCKENWOOD USA Corporation
- Address: 1440 Corporate Drive, Irving, TX 75038
- Telephone Number: 678-449-8879
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- this device must accept any interference received, including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
_ Note: _This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
ATTENTION: The product you have purchased is powered by a rechargeable battery that is recyclable. Please call 1-800-8-BATTERY for information on how to recycle this battery.
For Canada
CAN ICES-3 (B)
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
For U.S.A. and Canada
The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue), exposure of low-level RF that does not produce heating effects causes no known adverse health effects. Many studies of low-level RF exposures have not found any biological effects.
Some studies have suggested that some biological effects might occur, but such findings have not been confirmed by additional research. HA-A18T has been tested and found to comply with FCC/ISED radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the ISED radio frequency (RF) Exposure rules.
PRECAUTIONS
WARNING
- Do not listen at high volume for an extended period. Do not use while driving or cycling.
- Pay special attention to traffic around you when using the headphones outside. Failure to do so could result in an accident.
- This product with a built-in battery shall not be exposed to excessive heat such as sunshine, fire or the like.
- This product contains rechargeable battery, which is not replaceable.
- Danger of explosion if user replaced battery. Do not replace battery user own self.
To prevent possible hearing damage, do not listen at high volume levels for long periods.
Warnings for battery
- Please do not handle the battery in the following manners.
- It can lead to an explosion or leakage of flammable liquids and gases.
- Dispose in fire, discard, crush or cut
- Leave in extremely high temperature environment
- Leave in extremely low pressure environment
For U.S.A.
Hearing Comfort and Well-Being
- Do not play your personal audio at a high volume. Hearing experts advise against continuous extended play.
- If you experience a ringing in your ears, reduce volume or discontinue use.
Traffic Safety
- Do not use while operating a motorized vehicle. It may create a traffic hazard and is illegal in many areas.
- You should use extreme caution or temporarily discontinue use i n potentially hazardous situations.
- Do not turn up the volume so high that you cannot hear sound around you.
How To Use
- Make sure to charge the earphones before use.
BATTERY
- Ensure the indicators light up.
CONNECT
-
The indicator on one side of the earphones flashes quickly, while the indicator on the other side flashes twice slowly and repeatedly.
-
Select “JVC HA-A18T” from the device list.
-
Flashes slowly
BUTTONS USE
- Ensure the “JVC” logo is on the upper side, and fit it to your ear by adjusting the position.
POWER
-
After using, set firmly for charging.
-
When the charging terminals are dirty or dusty, it may affect the charging performance. Gently wipe the charging terminals regularly with cotton swab.
SCAN
For detailed operations such as phone call, troubleshooting and information on the European Guarantee, please refer to the user manual.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by JVCKENWOOD Corporation is under license. Other trademarks and trade names are those of their respective owners.
For Customer Use
Enter the Model No. and Serial No. (on the charging case) below. Retain this information for future reference.
- Model No. ……………………….
- Serial No. ……………………….
IC: 12522A-A25T
FCC ID: 2AKMBHA-A25T
© 2023 JVCKENWOOD Corporation
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>