EMILIA CK90TBLED 90cm Square Profile Rangehood Instruction Manual

: June 4, 2024
: Emilia

Table of Contents

EMILIA CK90TBLED 90cm Square Profile Rangehood Instruction Manual
RECOMMENDATIONS AND SUGGESTIONS
- IMPORTANT INSTALLATION NOTES
- IMPORTANT OPERATION NOTES
INSTALLATION & USE
- OPERATION OF CONTROLS
ELECTRICAL INSTALLATION
- INSTALLING THE HOOD
- INSTALL FILTERS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

EMILIA CK90TBLED 90cm Square Profile Rangehood Instruction Manual

Model CK90TBLED
Square profile 90cm rangehood INSTRUCTION MANUAL AND INSTALLATION GUIDE Please read this guide before installing and using the hood Glam Gas Australasia Pty Ltd
48 Percy Street Auburn, NSW 21442PO BOX 63 Blackwell PO South Granville NSW 2142 Tel 1 300 307 917 www.glemgas.com.au

Product Specification & Technical Parameters

Model CK90TBLED

Rated Voltage 230V Rated Power Frequency S0Hz

Light Power lx20W MAX

Motor Power 230W

Total Power 250W

Motor Single

Diameter of Outlet Adapter 150mm

Dimension| (mm)| W900X| DS00| X| H570min/1050max

RECOMMENDATIONS AND SUGGESTIONS

IMPORTANT INSTALLATION NOTES

The manufacturer will not be held liable for any damages resulting from incorrect or improper installation. Please read this instruction manual before installing and using this range hood. Please keep this instruction manual in a safe place for future reference. Only a qualified and trained service technician can undertake the work of installation and servicing.

Check that the main voltage corresponds to the one indicated on the rating plate fixed inside the hood.
If the hood is used in conjunction with non-electrical appliances (e.g. gas burning appliances), a sufficient degree of ventilation must be guaranteed in the room in order to prevent the back flow of exhaust gas. The kitchen must have an opening directly with the open air in order to guarantee the entry of clean air.
Australian safety standards set a minimum distance 650mm above a gas cooktop and 600mm above an electric cook-top. Our recommended best functional height for our rangehoods is 750mm above a gas cooktop, and 650mm over an electric cook-top.

IMPORTANT OPERATION NOTES

This range hood has been designed only for domestic use.
Never use the hood for purposes other than the extraction of kitchen smells during domestic cooking.
Never leave high naked flames under the hood when it is in operation.
Adjust the flame intensity to direct it onto the bottom of the pan making sure flames do not come up around the sides of the pan.
Deep fryers must be continually monitored during use as overheated oil can burst into flame.
The hood should not be used by children or persons who are not instructed in its correct use.

MAINTENANCE

Correct maintenance of the range hood will assure proper performance.
Disconnect the hood from the main supply before carrying out any maintenance work.
Clean and/or replace aluminum grease filters and activated charcoal filters after specified period of time.
Clean the hood using a damp cloth and a neutral liquid detergent.

DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of such waste separately for special treatment is necessary.

WARNING!!
In certain circumstances electrical appliances may be a danger hazard.

Do not check the status of the filters while the cooker hood is operating
Do not disconnect the appliance with wet hands.
Avoid free flame, as it would do damage to the filters from a fire hazard.
Constantly check food frying to avoid that the overheated oil may become a fire hazard
Disconnect the electrical plug prior to any maintenance or servicing.
Children don’t recognize the risks of electrical appliances. Use the appliance only under supervision of adults and keep it out of the reach from children.

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.
Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) to prevent back drafting.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
Ducted fans must always be vented to the outdoors.
- Don’t use this product outdoors.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities. Or persons with a lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
- There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels.
- There is a fire risk if cleaning is not carried out in accordance with instructions.
- The exhaust air must not be discharged into a flue which is used for exhausting fumes from other appliances burning gas or other fuels.

DIMENSIONS

INSTALLATION & USE

OPERATION OF CONTROLS

The hood is operated using the touch control panel. The on/off symbol controls the hood power on and off. The light symbol turns the shadow proof light on and off. The fan symbols control the fan speed on 3 settings, low, mid speed and booster for stir frying type applications.

Grease filters
The grease filters should be cleaned frequently. Use a warm detergent solution. The grease filters are washable and can be washed in a light cycle of a dishwasher. This may cause discolouration but does not affect the function of the filters See “INSTALL FILTERS” section for removal and installation instructions.

INSTALLING THE DUCTWORK

Caution: To reduce fire risk, use metal ducting. The outlet is 150mm diameter – reducing the diameter will increase noise levels.

Decide where the ductwork will run between the hood and the outside.
A straight, short duct run will allow the hood to perform most efficiently.
Long duct runs, elbows, and transitions will reduce the performance of the rangehood. Larger diameter ducting should be considered for best performance for longer duct runs.
The air must not be discharge into a flue that is used for exhausting fumes from appliances burning gas or other fuels. “Regulations concerning the discharge of air have to be fulfilled”.
Install wall cap. Connect round metal ductwork to cap and work back towards hood location. Use duct tape to seal the joints between ductwork sections.

ELECTRICAL INSTALLATION

Electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards. This range hood must be properly earthed. Turn off electrical power at power board before wiring. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

INSTALLING THE HOOD

Carefully remove the plastic protective film from all exterior surfaces of the hood and chimney prior to final installation.
At least two people will be required to mount the hood.

Height over cooktop
Referring to the Australian standard AS/NZ 5601.1:2013 the minimum hood distance above a cooktop must not be less than 650mm for gas and 600mm for electric or induction cooktops.
We suggest a height of 750mm above the cooktop as a good functional height. Heights over 750mm above the cooker are at the installer’s and user’s discretion – understanding that there may be a loss of extraction efficiency.

Secure the hood mounting bracket to the wall using (3) ST 5 x 45mm mounting screws and anchors to suit the wall. Align the hood body with the hood mounting bracket. Gently lower the hood until it securely engages the bracket.
Fix the discharge collar into the air outlet adapter.
Attach an adequate length of 150mm round duct to the air outlet adapter. Reducing the outlet diameter will increase noise levels.
Carefully slide the flue chimney top piece down inside the decorative flue bottom piece. Carefully place the decorative flue bottom into the recessed area of the top of the rangehood body.
Secure the flue chimney mounting bracket to the wall using (2) ST 2.9 x 14mm mounting screws and wall anchors.
Raise the flue chimney top until its holes align with holes in the chimney mounting bracket (located on the wall).
Level the hood and secure the chimney with 2 chimney bracket screws.
Fix the flue chimney bottom with 3 screws from inside of body.

INSTALL FILTERS

To remove the grease filter, push in on the metal latch tab. This will disengage the filter from the hood. Tilt the filter downward and remove.
To install the grease filter, align rear filter tabs with slots in the hood. Push in the metal latch tab, push filter into position and release. Make sure the filter is securely engaged after assembly.
Optional charcoal filter (optional), lock it until the stop click is heard.
Install grease filter after charcoal filter is installed.

GLEM GAS AUSTRALASIA PTY. L lD. PRODUCT WARRANTY
Thank you for choosing an Emilia Glam Gas Appliance, the purchase of this appliance is an important investment in your home and so to protect your investment we urge you to complete the registration card attached, please return it immediately. if IS A Warranty REQUIREMENT THAT PROOF OF PURCHASE BE PROVIDED PRIOR TO REQUESTING A SERVICE CALL. THIS Warranty SHALL NOT APPLY IF THE APPLIANCE WAS NOT INSTALLED BY A LICENSED TECHNICIAN AND PROOF IS NOT SUPPLIED. The benefits conferred by this warranty are in addition to all other conditions and warranties in respect of this product which the consumer may have under the Trade Practices Act 187 4 of the Commonwealth of Australia and/or similar State or Territory Laws. Our goods some with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

Glam Gas Australasia Pty Ltd warrants, this appliance to be free from defects in workmanship and materials for a period of:

Where the appliance is intended to be used and is used for DOMESTIC USE – 24 MONTHS FROM DATE OF DELIVERY TO THE ORIGINAL PURCHASER.
Where the appliance is intended to be used and is used for COMMERCIAL USE – 90 DAYS FROM DATE OF DELIVERY TO THE ORIGINAL PURCHASER.

Glam Gas Australasia Pty Ltd, during the period of warranty, will at its option, and subject to the terms and Conditions stated below, repair or replace free of charge this appliance or any component part, which upon examination by Glam Gas Australasia Pty Ltd. is found to be defective.

This Warranty SHALL NOT APPLY:

If the rating plate has been removed or the serial number or other details on it have been removed or rendered illegible.
If the appliance is connected to any voltage other than shown on rating plate.
If the appliance has been subjected to misuse, abuse accident or want of care.
If the appliance has been installed, operated or maintained contrary to the instructions supplied by Glam Gas Australasia P/L.
If any defect or failure is due to connection to an inadequate or faulty power supply.
If damage is caused by foreign objects in or on the appliance or by reason of its use for purposes other than that for which it was delivered.
If a repair has been made or attempted by the purchaser.
Where the appliance is installed outside an 80km radius from the GPO of any Australian Capital City to freight and travel costs beyond that radius.

This warranty does not cover any glass damage or replacement of light bulbs. Parts covered under warranty that need replacing i.e.: seals, knobs or filters. These can be posted to customer to put on at their
discretion.
This Warranty is given by Glam Gas Australasia Ply Ltd and no other person or organization is authorized to vary its provisions and conditions.
Complete this section and keep it for your own record.