emcopure 2 Surface Mounted Illuminated Mirror Cabinet Instruction Manual
- June 11, 2024
- EMCO
Table of Contents
emcopure 2 Surface Mounted Illuminated Mirror Cabinet Instruction Manual
Please read these installation instructions carefully before installing the components. Always have these instructions readily available and store them in a safe place. The product may only be installed in dry rooms or in bathrooms that are protected against splashing water. Installation in damp locations such as saunas, swimming pools and shower areas is not permitted. Always ensure that rooms are adequately ventilated to prevent mold growth. The product may be installed only by trained specialists. EMCO Bad GmbH assumes no liability for damages that occur through non-compliant installation and use.
CAUTION: The universal fastening accessories supplied with the product
are not suitable for all substrates. Please only use screws and plugs that are
suitable for the substrate concerned.
Therefore, before using the accessories, please carry out a thorough check to
ensure that the fastening accessories supplied with the product are suitable
for the intended substrate. Replace any broken glass.
Electrical connection for Pure 2/Flat 2 cabinets
-
The electrical installation must be carried out by a qualified electrician in accordance with DIN VDE 0100-701 / IEC 60364-7-701
be taken! National and local regulations must be taken into account. The installation of the product must take place outside of the protection zones 0, 1 and 2. -
The product must not be put into operation if it is
-
The product may only be repaired by the manufacturer or a service technician appointed by
-
The connection cable is in a closed wall lamp connection box in accordance with DIN / VDE 0100 Part 559/2009 – 06 to be
-
The product is delivered without connection Advice from specialists may be required for the connection be. For connection to the supply network, only connection terminals in accordance with EN 60998-2-1 be used. Three or four terminals are required(min. 1.5mm², min. 240V, 16A EN 60998-2-1).
-
Use of the product is only permitted for indoor The product meets the requirements of protection class IP20.
-
The light source of this lamp may only be replaced by the manufacturer or a service technician commissioned by
-
The power supply unit of the product may only be replaced by the manufacturer or a service technician appointed by
-
Mirror cabinet Style: this product contains a light source of energy efficiency class E and
-
Mirror cabinet Design: this product contains a light source of energy efficiency class
-
Mirror cabinet Classic: this product contains a light source of energy efficiency class
-
After removing all screws and covers, the light source and control gear can be replaced by a qualified person be expanded or
-
[]](https://manuals.plus/wp-content/uploads/2023/05/emcopure-2-Surface-Mounted-Illuminated-Mirror-Cabinet-Instruction-Manual_6.png)
[]
](https://manuals.plus/wp-content/uploads/2023/05/emcopure-2
-Surface-Mounted-Illuminated-Mirror-Cabinet-Instruction-Manual_7.png)
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>