electriQ iQLEAN-CR01 Robot Vacuum Cleaner User Manual

electriQ iQLEAN-CR01 Robot Vacuum Cleaner User Manual

SETTLING IN OK?
We hope this has been helpful to you.
We would love to see how you’re getting on with your new purchase,
so please share any snaps you have on the platform of your choice below.
Our community awaits your uploads – Snap, tag and hashtag away!

Facebook
Instagram

WE’RE HERE TO HELP
Should you have any problems or questions with your purchase,
please contact a member of our customer service team.
0330 390 3061
support@electriQ.co.uk
Mon-Fri I 9am to 5pm
Unit JG, Lowfields Business Park,
Lowfields Way, Elland
West Yorkshire, HXS 9DA

SAFETY PRECAUTIONS

IMPORTANT

• Carefully read the instructions before operating the unit. Please retain the manual for future reference.

• This appliance is for indoor use only.

• Rating: This unit must be only connected to a 220-240 V, 50/60 Hz outlet.

• Always check the rating label against the electrical supply.

• If you are in any doubt about the suitability of the electrical supply have it checked and, if necessary, tested by a qualified electrician.

• This robotic vacuum cleaner has been tested and is safe to use.
  However, as with any electrical appliance – use it with care.

• Disconnect the power plug from unit before dismantling, assembling or cleaning.

• Do not clean the unit by spraying it or immersing it in water.

• Never operate this appliance if the cord or power supply is damaged. Ensure the power cord is not stretched or exposed to sharp objects / edges.

• Do not use the appliance if any part or any accessory is damaged or defective.

• A damaged power supply should be replaced only with original parts from the manufacturer.

• Avoid touching any moving parts of the appliance.

• Never insert fingers or any other objects while machine is in operation.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities. It is also not intended for use by those with a lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

• Do not leave children or animals unsupervised with this appliance.

• Only use the original battery or charger from the manufacturer, any third-party components may damage the unit.

• Any service other than regular cleaning should only be performed by an authorised service representative. Failure to comply could result in a voided warranty.

• Do not use the appliance for any purpose other than its intended use.

• Do not use the appliance in places with high humidity (>80%RH).

• Do not immerse the robot in water or other liquids. If the robot is immersed in water or other liquids, do not touch it with hands. If the appliance is immersed in water or other liquids, discard it.

• Do not use if there are liquids on the floor.

• Do not use in an environment where there is a risk of fire or explosion.

• Do not use to clean printer toner spilled on the floor as this could cause a fire.

• Before using the robot cleaner, remove any fragile objects from the floor e.g. glasses, bottles, candles, lamps. Also removes any sharp metals, nails, sharp glass pieces or any other objects that could block or damage the robot.

• Do not place any object on the top of the robotic cleaner.

• Do not leave any fragile objects on the side of tables, cabinets etc where the robot could bump into and cause them to fall.

• Before operating the robot, ensure that there are no obstructions which could cause the robot to become trapped or jammed.

UNIT SAFETY PROTECTION AND PERFORMANCE TIPS

• Make sure unit is assembled correctly before use.
• Charge for 6 hours before operating for the first time. If not using the robot for a long time please fully charge and remove the battery.
• Always use the battery charger or base provided.
• Clean the robot and brushes regularly. Empty and vacuum the dust container.
• If the robot becomes entangled, remove brushes, clean the debris and reassemble.

BATTERY CARE

To get the most from the robot’s battery, please charge the product fully and remove it from the robot before any expected long periods of inactivity. To prevent the battery from self-discharging please charge every three months. If it reaches a level of deep discharge it may not be able to charge. In this case please contact product support.

PRODUCT OVERVIEW

The robot vacuum cleaner is designed for cleaning homes, small offices and other small rooms. It provides excellent cleaning for a variety of floor types including:

• Wooden floors
• Tiled floors
• Stone floors
• Short-pile carpets (up to 2 cm deep)

FEATURES OF THE ROBOT VACUUM CLEANER

• SLAM (simultaneous localisation and mapping).
• Navigation by camera, VSLAM (visual simultaneous localisation and mapping) technologies.
• 2 in 1 e-tank containing dust box with vacuum function and water tank which can be controlled by the user.
• Four smart cleaning modes designed to suit your different cleaning needs. They can be controlled by the remote control and through the app.
• Great cleaning efficiency and power saving.
• Charging base both recharges the vacuum’s battery and unloads the robot’s dust into its own dust box for ease of emptying.
• User-friendly design ­ Press the power button to start cleaning, see third party control on page 19.

PARTS LIST

Please view this list before commencing operation.

PRODUCT DIAGRAMS

TOP

BOTTOM

E-TANK

MOPPING PLATE

DUST BOX

CHARGING BASE

INITIAL SET UP

SIDE BRUSHES
Install the side brushes according to the L’ (left) andR’ (right) markings.

BUMPER PROTECTORS
Remove the bumper protectors.

• Arrange the furniture so that the robot can move around freely.
• Block off hazards such as stairways and bannisters to prevent the robot from danger.
• Take care to remove small objects from the floor, for example power leads, toys and such as these may get tangled in the robot’s mechanism. Do not use the mopping function on carpet and if you have any loose rugs, roll them up to keep them away from the vacuum.

2 IN 1 E-TANK

SETUP OF THE BASE
CHARGING THE ROBOT
Please fully charge the robot before first use. Charging time is approximately 6 hours.

There are two ways to charge the robot:
a. On the charging base.
b. Charging directly from the power adapter. When charging, the indicator light flashes. When it is complete the indicator turns green. During cleaning the robot monitors its own charge level and returns to the charging base when required. You can also put the robot into recharging mode by pressing the button on the remote control or on the app.
Please note:

• Do not operate the charging base in areas with strong reflections such as direct sunlight or mirrors. If this is unavoidable please cover the reflective surfaces up, so that the charging base is not in direct sunlight.
• For electrical safety and to prevent leaking to the floor, do not charge the robot with the water tank fitted.
• During charging do not press any button.

OPERATION

The product has different cleaning modes to cater for different cleaning needs. The cleaning mode can be chosen on the robot, on the remote control or on the app.
REMOTE CONTROL

CONTROL PANEL

APP CONTROL

Before you start:

• Ensure the router provides a standard 2.4GHz connection.
• If the router is dual band ensure that both networks have different network names (SSID). The provider of the router / Internet service provider will be able to provide advice specific to the router.
• Place the cleaning robot as close as possible to the router during setup.
• Once the app has been installed on the phone, turn off the data connection, and ensure the phone is connected to the router via Wi-Fi.

DOWNLOAD THE APP TO THE PHONE

Download the WeBack app, from the chosen app store, using the QR codes below, or
by searching for the app in the chosen store.

https://play.google.com/store/apps/details?id=com.yugong.Backomehttps://apps.apple.com/us/app/weback/id1066738633

REGISTER/LOG IN

ADD DEVICE

CONTROLLING THE DEVICE THROUGH THE APP

THE DEVICE SCREEN
The device screen is the main control screen for the cleaning robot, providing access to the controls to amend the functions and settings.

NOTE: Due to continuous development of the app, the layout and availability of features are subject to change.

THE SETTINGS SCREEN

This screen gives you the option to turn off the robot’s voice and update some of the device’s basic settings.
Voice switch – switch voice on and off.
Crossing Obstacles – whether to allow robot to cross 1cm tall obstacles.
Breakpoint Cleaning – permit robot to break off from a cleaning job to recharge then continue the remaining clean.
Set Remark – rename the Robot.
Schedule – set a schedule for the robot to clean at a specified time in the future.
Area unit – choose between ft² or m².
Shared device – share access to the controls of the cleaning robot with friends and family.
Check for update – update to the latest firmware.
Model – this is the unique identifier.
Upload problem log – upload error file for support.
Third Party Control – This allows the unit to be integrated with the favourite home automation hardware such as Google Home and the
Amazon Echo.

CLEANING AND MAINTENANCE

DUST BOX AND FILTER CLEANING

E-TANK MAINTENANCE

CLEANING THE BRUSHES

MAINTENANCE OF CHARGE TERMINALS AND WHEELS

Note: the charging terminals on the charging base and the underside of the robot contain sensitive electronic components. Do not use water to clean them, use only a dry cloth. Clean the charging contacts.

TROUBLESHOOTING

TECHNICAL SPECIFICATIONS

Model name: iQlean-CR01

CHARGING BASE

ROBOT

DECLARATION OF CONFORMITY
Hereby, electriQ declares that this Robot Vacuum Cleaner is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.electriQ.co.uk/content/declaration-of-conformity

electriQ UK SUPPORT

www.electriQ.co.uk/support www.electriQ.co.uk Call: 0330 390 3061
Office hours: 9AM – 5PM Monday to Friday Unit J6, Lowfields Business Park Lowfields Way, Elland West Yorkshire, HX5 9DA

Recycling facilities are now available for all customers at which you can deposit the old electrical products. Customers will be able to take any old electrical equipment to participating sites run by their local councils. Please remember that this equipment will be further handled during the recycling process, so please be considerate when depositing the equipment. Please contact the local council for details of the local household waste recycling centres.

References

• Buy electriQ Appliances Online | TVs | Ovens | Dehumidifiers | Security

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>