Sunco LED Utility Shop Lights Instruction Manual

Table of Contents

Sunco-LED-Utility-Shop-Lights-PRO

$Sunco-LED-Utility-Shop-Lights- $1$$

This fixture is to be installed directly beneath a ceiling-mounted receptacle.
This fixture has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric shock. This plug will only fit a polarized outlet one way.
If the plug does not fully fit the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Do not use with an extension cord unless plug can be fully inserted.
Do not alter plug.

Turn off circuit breaker before installation.
CAUTION: Mounting surface must be able to support weight of fixture.
Drill 2 pilot holes into ceiling. Holes should be 46.36 inches apart.
- Dry Wall: 7/32″ drill bit
- Wall Stud: 9/64″ drill bit
Insert expansion anchors into pilot holes.
Tighten screws into expansion anchors.
- Leave about 0.17″ gap between the screw heads and mounting surface.
  NOTE: Space fixture to suit your lighting plan and power chord length (60″).4 units maximum.
Align fixture to screws.
When holes are aligned, push fixture up.
- Slide to secure.
Plug in power cord to electrical outlet.
Turn on circuit breaker and test light.

WARNING
To reduce the risk of fire, electric shock, or injury:

Turn off circuit breaker before installing this fixture.
This product should be installed by a person familiar with the construction and operation of the product and hazards involved. Safety eyeglasses and gloves are recommended.
Abide by related regional and local laws or regulations.
Proper grounding is required to ensure safety.
This fixture was designed for daisy chains only. Using it for other purposes will void warranty.
Check for shipping damage before installing. If the product is damaged, do not use it.
Keep fixture away from corrosive substances.
Suitable for damp locations at temperatures ranging from 40F to 1130F. Not for use where directly exposed to water.
Clean fixture regularly to ensure proper operation. Do not clean with harsh solvents.
Use safety precautions and abide by regional and local laws or regulations.
This product is not compatible with 3rd party sensors or dimmers.
This product is not compatible with photo controls.
This product is not compatible with occupancy sensors.
This product is not compatible with timing devices.

$Sunco-LED-Utility-Shop-Lights- $8$$

This fixture is to be installed directly beneath a ceiling-mounted receptacle.
This fixture has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric shock. This plug will only fit a polarized outlet one way.
If the plug does not fully fit the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Do not use with an extension cord unless plug can be fully inserted.
Do not alter plug.

Turn off circuit breaker before installation.
CAUTION: Mounting surface must be able to support weight of fixture.
Drill 2 pilot holes into ceiling. Holes should be 46.83 inches apart.
- Dry Wall: 7/32″ drill bit
- Wall Stud: 9/64″ drill bit
Insert expansion anchors into pilot holes.
NOTE: Space fixture to suit your lighting plan and power chord length (60″).4 units maximum.
Tighten screw eye hooks into expansion anchors.
Insert S-hook into each end of mounting chains.
Loop other end of S-hooks into fixture’s keyhole slots.
- Crimp ends to secure
Secure fixture to ceiling by hanging non-crimped portion of S-hooks onto eye hooks.
- Adjust chain length as needed.
Secure fixture power cord to mounting chain using zip tie.
Plug in power cord to electrical outlet.
Turn on circuit breaker and test light.