Pro-Ject Audio System RS2 Power Box Instruction Manual
- June 10, 2024
- Pro-Ject Audio System
Table of Contents
Pro-Ject Audio System RS2 Power Box
Dear music lover,
Thank you for purchasing a Pro-Ject Audio Systems Power Box RS2 Sources.
In order to achieve maximum performance and reliability you should study these
instructions for use carefully.
Warning of a hazard for the user, the unit or possible misuse
Important notice
Safety Instructions
AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the voltage in your area meets the voltage requirements printed on the power supply.
Never handle the device while your hands are wet or damp.
Avoid letting liquids enter the device. Never place any item containing liquid, such as a flower vase on or near the device. Never spill any liquid on the device. Never place any naked flame sources, such as lighted candles on or near the device. The product shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.
Using the product
Power Box RS2 Sources is designed to power Box Design units from the RS and RS2 lines with 20V DC power input: Phono Box RS2, Pre Box RS2 Digital, DAC Box RS2, CD Box RS2 T, CD Box RS, Pre Box RS Digital, Head Box RS, DAC Box RS, Stream Box RS, Pre Box RS.
Make all connections whilst the Power Box RS2 Sources is switched off or disconnected from the mains.
Interconnection cables are included in the packaging. Original power supplies are no longer required. Ensure that you use the correct cable for your device: The cables are marked on both ends. In case of any doubts, consult user manuals of all connected products or ask your dealer.
Make sure that Input AC selector matches mains voltage in your country.
Main power switch
The toggle switch on the front panel turns the unit on or off. The blue LED above the switch shows that the unit is switched on.
Technical specifications Pro-Ject Power Box RS2 Sources
Input Power supply: 115V/230V AC
Output voltage/current/ripple: 4 x 20V ±0,5%/ 2A/ max. 6mV pp
Dimension (W x D x H): 206 x 209 x 71
Weight: 3550 g
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information, please contact your dealer for further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions for use. Modification or change to any part of the product by unauthorized persons, release the manufacturer from any liability over and above the lawful rights of the customer
Copyright, trademarks
Pro-Ject Audio Systems is a Registered Trademark of H. Lichtenberger. This guide was produced by: Pro-Ject Audio Systems Copyright © 2022. All rights reserved.
The information was correct at the time of going to press. The manufacturer reserves the right to make changes to the technical specification without prior notice as deemed necessary to uphold the ongoing process of technical development.
Declaration of Conformity
We, Canor spol. s r.o. Družstevná 13925/39 08006 Slovakia (manufacturer) and
Pro-Ject Audio Systems a division of Audio Tuning GmbH Margaretenstrasse 98 1050 Vienna, Austria (distributor)
declare under our responsibility that the product is in conformity with the
provisions of Directives:
2014/35/EU including amendments
2014/30/EU including amendments
STN EN 62368-1:2015 – Safety
STN EN 55035:2018 – Electromagnetic compatibility of multimedia equipment
– Immunity requirements
STN EN 55032:2015 – Electromagnetic compatibility of multimedia equipment
– Emission requirements
© Pro-Ject Audio Systems · Pro-Ject Power Box RS2 Sources · Revision 2022.10.18
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>