poly VVX D2320 Wireless Handset and Charger User Guide
- June 10, 2024
- Poly
Table of Contents
poly VVX D2320 Wireless Handset and Charger User Guide
Need more information? Go to your phone’s Support page at poly.com/support.
Package Contents
VVX D230 Handset Charger
VVX D230 Wireless Handset
Belt Clip
VVX D230 Battery
2.5 mm to 3.5 mm Headset Adapter
AC Power Cord and Adapter
Screws and Wall Anchors
Quick Start
Features
Connect Cable
Register a VVX D230 Wireless Handset
After the VVX D230 Base Station is powered and running, you can register up to 10 wireless handsets to the base station.
To register the wireless handset with the base station:
-
On the wireless handset, go to Menu > Settings > Registration, then select Register.
-
Press and hold the Find button on the base station for at least five seconds.
The wireless handset displays Register to VVX-D230-XXX, where “XXX” is a number unique to the phone. -
Select Yes to confirm the registration with the base station.
When the registration is successful, the screen displays Registration Successful
Install Handset Battery
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
For optimum performance, charge the battery for a minimum of four hours before first use.
To get a replacement AC adaptor, visit our website at poly.com/support.
Power Adaptor Supplier Information:
TEN PAO INTERNATIONAL LTD.
MODEL NO.: SOO8ACM0500120
Battery Supplier Information:
YIYANG CORUN BATTERY CO., LTD.
MODEL NO.: Ni-MH 50AAA800*2
Wallmount Instructions
Safety and Regulatory
BY USING THIS PRODUCT, YOU ARE AGREEING TO THE TERMS OF THE END USER LICENSE AGREEMENT (EULA) AT: poly.com/support. IF YOU DO NOT AGREE TO THE TERMS OF THE EULA, DO NOT USE THE PRODUCT, AND YOU MAY RETURN IT IN THE ORIGINAL PACKAGING TO THE SELLER FROM WHOM YOU PURCHASED THE PRODUCT.
The Terms and Conditions applicable to Poly’s Limited Warranty for this product are found at poly.com/support.
IMPORTANT SAFETY INSTRUCTIONS
When using your telephone equipment, basic safety precautions should always be
followed to reduce the risk of fire, electric shock, and\ injury to persons,
including the following: 1. Do not use this product near water, for example,
near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or
near a swimming pool; 2. Avoid using a telephone (other than a cordless type)
during an electrical storm, as there may be a remote risk of electric shock
from lightning; 3. Do not use the telephone to report a gas leak in the
vicinity of the leak. SAVE THESE INSTRUCTIONS.
INSTRUCTIONS.
The marking of nameplate and input rating is located at the bottom of the
telephone. The marking instruction for using wireless handset is located at
battery compartment side enclosure.
BATTERY STORAGE AND USAGE
In order to avoid battery misuse, avoid the following scenarios:
- high or low extreme temperatures that a battery can be subjected to during use, storage, or transportation; and
- low air pressure at high altitude
- replacement of a battery with an incorrect type that can defeat a safeguard;
- disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
- leaving a battery in an extremely high temperature environment that can result in an explosion or the leakage of flammable liquid or gas;
- a battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
Warning! The product detailed (ITE) in this document is to be connected only to PoE networks without routing to the outside plant.
CE
VVX D230 is marked with the CE mark. This mark indicates compliance with EU
Radio Equipment Directive (RED) 2014/53/EU, RoHS
Directive 2011/65/EU, and Commission Regulation 278/2009. A copy of the
Declaration of Conformity to the essential requirements may be found at
www.poly.com/conformity.
UK Declaration of Conformity
Hereby, Plantronics Limited (UK) declares that the radio equipment type as
described in the accompanying documentation is in compliance with the relevant
statutory requirements. A copy of the Declaration of Conformity to the
essential requirements may be found at
www.poly.com/conformity. VVX D230 Radio Operating
Frequency band: 1881.792-1897.344MHz. Max radio frequency power transmitted in
the frequency band in
which the radio equipment operates:<250mW SAR: Highest reported SAR: 1g Head
0.085 W/kg, 1g Body Worn 0.145 W/kg
For pluggable equipment, the socket-outlet (power adaptor) shall be installed
near the equipment and shall be easily accessible.
FCC PART 15
Privacy of communications may not be ensured when using this telephone.
Warning : Changes or modifications to this equipment not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must
accept any interferences received, including interference that may cause
undesired operation.
Caution: To maintain the compliance with the FCC’s RF exposure guideline,
place the base unit at least 20 cm from nearby persons.
For body worn operation, this handset has been tested and meets the FCC RF
exposure guidelines when used with the accessories supplied or designated for
this product. Use of other accessories may not ensure compliance with FCC RF
exposure guidelines.
NOTE: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This
equipment operates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
An adapter with Ferrite Core must be used with this equipment to ensure
compliance with the Class A FCC limits.
In accordance with Part 15 of the FCC Rules, the user is cautioned that any
changes or modifications not expressly approved by Poly could void the user’s
authority to operate the equipment.
Operating Ambient Conditions: Operating temperature: +32 to 104°F (0 to 40°C);
Relative humidity: 5% to 95%, noncondensing; Storage temperature: -40 to
+160°F (-40 to +70°C)
This product is rated 5V DC, 1.2A. When used with the optional external power
supply (S008ACM0500120, or similar rated PSU), the power supply shall be a
Listed power supply with a LPS output, rated 5V, min. 1.2A. Hearing Aid
Compatibility (HAC): This device is hearing aid compatible.
Australia Warning: This equipment will be inoperable when mains power fails.
Radiation Exposure Statement: The antenna used for this transmitter must be
installed to provide a separation distance of at least 20 centimeters from all
persons and must not be co-located or operating in conjunction with any other
antenna or transmitter. This portable device with its antenna complies with
FCC’s RF radiation exposure limits set forth for an uncontrolled environment.
To maintain compliance, this transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. FCC ID: M72-VVXD230
IC RF
This product meets the applicable Innovation, Science, and Economic
Development Canada Technical specifications. This device contains license-
exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and
Economic Development Canada’s license-exempt RSS(s). Operation is subject to
the following two conditions: 1) This device may not cause interference, and
2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Caution: To maintain the compliance with the Industry Canada’s RF exposure
guideline, place the base unit at least 20 cm from nearby persons. For body
worn operation, this handset has been tested and meets the Industry Canada RF
exposure guidelines when used with the accessories supplied or designated for
this product. Use of other accessories may not ensure compliance with Industry
Canada RF exposure guidelines. IC: 1849C-VVXD230
Privacy of communications may not be ensured when using this telephone.
FCC PART 68 AND ACTA
This equipment complies with Part 68 of the FCC rules and with technical
requirements adopted by the Administrative Council for Terminal
Attachments (ACTA). The label on the back or bottom of this equipment
contains, among other things, a products identifier in the format
US:AAAEQ##TXXXX. This identifier must be provided to your telephone service
provider upon request.
The plug and jack used to connect this equipment to premises wiring and the
telephone network must comply with the applicable Part 68 rules and technical
requirements adopted by ACTA. A compliant telephone cord and modular plug is
provided with this product. It is designed to be connected to a compatible
modular jack that is also compliant. An RJ45 jack should normally be used for
connecting to DECT IP Phone. See Installation Instructions in the user’s
manual.
This equipment may not be used with Party Lines. If you have specially wired
alarm dialing equipment connected to your telephone line, ensure the
connection of this equipment does not disable your alarm equipment. If you
have questions about what will disable the alarm equipment, consult your
telephone service provider or a qualified installer
If this equipment is malfunctioning, it must be unplugged from the modular
jack until the problem has been corrected. Repairs to this telephone equipment
can only be made by the manufacturer or its authorized agents. For repair
procedures, follow the instructions outlined under the Limited Warranty.
If this equipment is causing harm to the telephone network, the telephone
service provider may temporarily discontinue your telephone service. The
telephone service provider is required to notify you before interrupting
service. If advance notice is not practical, you will be notified as soon as
possible. You will be given the opportunity to correct the problem and the
telephone service provider is required to inform you of your right to file a
complaint with the FCC. Your telephone service provider may make changes in
its facilities, equipment, operation, or procedures that could affect the
proper funtioning of the product. The telephone service provider is required
to notify you if such changes are planned.
If this product is equipped with a corded or cordless handset, it is hearing
aid compatible.
If this product has memory dialing locations, you may choose to store
emergency telephone number (e.g., police, fire, medical) in these locations.
If you do store or test emergency numbers, please:
- Remain on the line and briefly explain the reason for the call before hanging up.
- Perform such activities in off-peak hours, such as early morning or late evening.
Plantronics B.V.
Scorpius 171 2132 LR Hoofddorp
The Netherlands
GETTING HELP:
For more information about installing, configuring and administering Poly
products or services, go to Poly Support:
poly.com/support
Poly
345 Encinal Street
Santa Cruz, California
95060
© 2022 Poly. All trademarks are the property of their respective owners.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>