Joybos JJYW-XZTB-MN12-RD Square Spin Mop User Manual
- June 10, 2024
- Joybos
Table of Contents
Joybos JJYW-XZTB-MN12-RD Square Spin Mop
Precautions
Warning:
- Do not expose to the sun or close to a heat source for a long time.
- Do not use strong acid or strong alkaline chemical cleaners to avoid damage the core parts of the mop bucket.
Important:
- It is recommended to replace the mop every 2-3 months to ensure a good cleaning effect.
- After using products such as cleaners, disinfectants, etc., please empty and clean the sewage in the mop bucket.
- This mop is based on the principle of waterwheel pump. After cleaning and using, it is normal if there be residual water in the bucket.
- Can be applied to smooth surfaces such as wooden floor tiles, ceramic tiles, marble, etc., as well as glass, showcases, porcelain walls, etc.
Product Description
- Barrel
- Lower rod
- Middle rod
- Upper rod
- Mop tray
- Handle
- Water inlet
- Water outlet
- Mop cloth
Product Installation
- Install the mop on the upper rod.
- Install the mop cloth on the mop tray.
When installing the mop, as shown in the figure above, align the mop tray and mop cloth concentrically, and then stick it on.
Mop Using Steps
- Put the mop plate and the cloth surface into the bucket, align the center of bearings in the drop zone.
- Open the lock and release the lower rod.
- Holding the handle position of the upper rod, press the rod down continuously.
- Pull the mop up firmly.
- Close the lock and start mopping the floor.
- Quick and hard press to open the locking plate and let the mop dry quickly
- Slowly and gently press the lock plate and the state is not open, it is the mop washing state
Mop Washing
Press 4-5 times in a row to complete the cleaning (slowly and gently press
for washing).
Mop Dry
Press 15-18 times in a row to complete the drying (hard and quick press for
drying).
Mop Wet
Press 7-10 times continuously to complete the cleaning.
Cleaning Instructions for the Clean Water Area and the Pump Area
Take out the cover of the clean water area and the pump area for easy cleaning
- Remove the cover of clear water area.
- Remove the cover of pump area.
- After cleaning, install it back.
Description of the product
Instructions for use
Method 1
Pour clean water directly into the clean water inlet.
Method 2
Open the lid of the clean water area by hand ⑧ Pour into the water, and then
close the lid tightly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>