PRTUKYT A9S Wireless Bluetooth Earphones User Manual
- June 10, 2024
- prtukyt
Table of Contents
PRTUKYT A9S Wireless Bluetooth Earphones
Overview
For initial use, make sure the earbuds and case are fully charged.
Charging the Case
Please charge the case via cable.
The led light flashes green while charging; The light keep constant on after
fully charged.
Activating Earbuds and Charging Earbuds Put both earbuds into the charging
case to activate and charge them.( pins need to be well-contacted).
The LED light will turn on red while charging and it turns off when the
earbuds are fully charged.
TWS Pairing and Connection with Cell Phone
Take both earbuds out of the case at the same time and they will auto power on
after 2-3 seconds. Both earbuds will auto pairing, at this moment the light on
one earbud flashes blue and the light on the other earbud flashes red & blue
alternately.
Search for “Model” in cellphone and tap to connect both earbuds with
cellphone.
Please insert both earbuds into charging case and repeat above steps if
earbuds fail to connect.
Wearing Earbuds
Functions
Power-on
Method 1: Take out both earbuds and they will auto power on.( LED lights flash
blue and red)
Method 2: Press MFB for2s to Power on ( LED lights flash blue and red)
Power-off
Method 1: Put the earbuds into the Charging case, then the earbuds will turn
off automatically for charging, the red indicator is on until fully charged.
Method 2: Press MFB for5 seconds to power off, red indicator turns on for l
seconds.
Reject Call
Press MFB for2s to reject incoming call.
Answer Call
Press 1 time MFB to answer incoming call.
Hang off
Double Press MFB to hang off.
Playback/ Pause
When playing music press MFB to pause it and press again to play it.
Next Song/Previous Song
When playing music, double press MFB on left earbud to skip track back word(previous song), double press MFB on right earbud to skip forward(next song) .
V-/V+
When playing music, Press three times MFB on left ear bud to turn volume down(V- )and press MFB on right earbud to turn volume up (V+).
Voice Assistant
When standby, press and hold MFB on left earphone for Long press ls until the “beep” sound happen to activate voice assistant ( Like: Siri).
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with FCC radiation exposure limits set forth for an
uncontrolled environment and it also complies with Part 15 of the FCC RF
Rules. This equipment must not be co-located or operating in conjunction with
any other antenna or transmitter.
End-users and installers must be provide with antenna installation
instructions and consider removing the no-collocation statement.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful including interference that may cause undesired operation.
Attentions
- If the earbuds is left unused for over two weeks, please recharge it periodically.
- Besureto use a SV DC,lAcharger made by qualified manufacturer.
- Ensure that the distance between your device and the earbuds not too far away, Ensure that nothing is blocking the signal between your device and the earbuds.
- The implementation of the earbuds function will be different due to different protocols supported by different wireless device.
- Don’t disassemble or modify your earbuds for any reason to avoid any damages and danger. Don’t over charging to avoid the outbreak of a fire.Avoid exposing the earbuds to extreme tern peratu res(below 0°C or above 45°C). Extreme tern peratu res can cause deformation of Earbuds components and reduce battery life and the lifespan of your earbuds.
- Don’t put the device’s LED lights close to humans’ or animals’ eyes.Do not use the earbuds during a thunderstorm. Thunderstorms can cause serious malfunction and increase the risk of electric shock.
- Do not clean the earbuds with harsh chemicals or strong detergents.
- Please follow our company’s operating instructions. If any damage or danger caused due to the improper use, the responsibility shall be undertaken by the operator.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>