JHS Pedals 3 Series Flanger Pedal Instruction Manual

June 10, 2024
JHS PEDALS

JHS Pedals 3 Series Flanger Pedal

JHS Pedals 3 Series Flanger Pedal-product

Product Information

3-Series Flanger

The 3-Series Flanger is a guitar effects pedal inspired by the classic analog flangers of the past. It features controls for Blend, Rate, and Intensity, as well as a Tape toggle that simulates tape flanging. The pedal has an input and output jack and requires a 9V DC negative center power supply that should not exceed 70mA.

Controls

  • Blend: This control blends in the flanger effect over your clean signal. Turn the knob right for increased flange, and experiment with lower positions for chorus-like tones.
  • Rate: Controls the speed of the flange. Turning the knob clockwise increases the speed.
  • Intensity: Controls the amount of flange. The Left is mild flanging, while the right is more extreme.
  • Tape: Toggle up moves the sound into tape-like sweeps with zero through flanging. This model is inspired by real tape flanging as done in studios by altering the speed of tape machines during playback.

Usage Instructions

  1. Connect your guitar to the input jack on the right side of the pedal.
  2. Connect your amplifier or another audio device to the output jack on the left side of the pedal.
  3. Connect your power supply to the pedal’s power input. Make sure to use a 9V DC negative center power supply that does not exceed 70mA.
  4. Turn on your amplifier or audio device, and gradually turn up the Blend control to add in the flanger effect.
  5. Adjust the Rate and Intensity controls to your desired settings to control the speed and amount of the flanging effect.
  6. Experiment with the Tape toggle to simulate tape flanging effects.
  7. When finished, turn off your amplifier or audio device and disconnect the power supply from the pedal.

CONTROLS

BLEND – This control blends in the flanger effect over your clean signal. Turn the knob right for increased flange and experiment with this knob in lower positions for “almost chorus” tones.
RATE – Controls the speed of the flange. Turning the knob clockwise increases the speed.
INTENSITY – Controls the amount of flange. Left is mild flanging, right is more extreme flanging.
TAPE – Toggle up moves the sound into tape-like sweeps with zero through flanging. This model is inspired by real tape flanging as done in studios by altering the speed of tape machines during playback.

JACKS

INPUT – 1/4” jack on the right side of the pedal.
OUTPUT – 1/4” jack on the left side of the pedal.
POWER – Requires 9V DC negative center power and consumes 70mA. Do not use more than 9V DC. You will void your warranty.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals