HALCYON T249 Track 1 Circuit Ceiling Mt Adaptor Spot Flood Instruction Manual
- June 10, 2024
- HALCYON
Table of Contents
HALCYON T249 Track 1 Circuit Ceiling Mt Adaptor Spot Flood
Product Information
The product is a T249 luminaire designed for indoor use only. It comes with an external flexible cable or cord that should be replaced exclusively by the manufacturer or a qualified person to avoid any hazards. This luminaire must be installed by a registered electrician to ensure electrical safety. Caution, there is a risk of electric shock when using this product. The product comes with a torque specification of 3-3.5kgf.cm for FIG-4 and 3.5-4kgf.cm for FIG-5. It has three wires, green/yellow for ground, blue for neutral, and brown for live. FIG-2-A is for concrete installation, and FIG-2-B is for wood board installation. For wood board installation, please make sure that the thickness of the wood board is not less than 5mm.
Product Usage Instructions
- Make sure to use the product indoors only.
- In case the external flexible cable or cord is damaged, replace it with the help of the manufacturer or a qualified person to avoid any hazards.
- Hire a qualified registered electrician to install the luminaire properly to prevent damage and maintain electrical safety.
- Be cautious of the risk of electric shock while using the product.
- Refer to FIG-4 for torque specification and connection of wires; use a torque of 3-3.5kgf.cm.
- Refer to FIG-5 for torque specification and connection of wires; use a torque of 3.5-4kgf.cm.
- For concrete installation, refer to FIG-2-A.
- For wood board installation, refer to FIG-2-B and make sure the thickness of the wood board is not less than 5mm.
- Switch the product off before installation or changing any parts.
- After installation, switch the product on and check for proper functionality.
For indoor use only
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard This luminaire must be installed by a qualified Registered Electrician to prevent damage to the luminaire and maintain electrical safety. Caution,risk of electric shock.
SWITCH
INSTALLATION INSTRUCTIONS
