HALCYON R853 LED Recessed Luminaire Instruction Manual
- June 10, 2024
- HALCYON
Table of Contents
HALCYON R853 LED Recessed Luminaire Instruction Manual
Driver Sold Separately Constant Current – Wire in series
Do not connect luminaire/s to driver if driver is live. Inrush current from
live driver will cause instant failure of all connected luminaires. Do not
switch secondary side.
Recommended Drivers
This luminaire must be installed by a qualified Registered Electrician to prevent damage to the luminaire and maintain electrical safety.
Installation Directions
- Switch off mains power supply
- Connect Driver to mains voltage cable (L, N)
- Carefully install downlight into pre-cut 150mm hole.
- Turn on mains power and switch on lighting circuit.
Cutting of holes prior to receiving goods is entirely at the risk of the
installer.
10 Basalt Place, East Tamaki, Auckland, PO Box 58-501, Botany, Manukau 2163,
Auckland, New Zealand
Ph (0064 9) 273-9177
Fax (0064 9) 273 9155
Email: sales@halcyon.co.nz
Web: www.halcyonlights.co.nz
DO NOT INSTALL THROUGH JOIST, BEAM, RAFTER OR CEILING BATTEN.
Caution: Recessed luminaires and their associated equipment may pose a risk of fire or damage to property if not installed and maintained correctly.
Halcyon Non IC rated luminaires are completely safe to install in sarked
timber ceiling linings with a gauge of less than 20mm. Halcyon accepts no
responsibility if the timber used is
not treated correctly and dries out, crack or warps over time due to the
constant low heat from the aforementioned “Non IC Rated” LED recessed
lighting.
This data sheet contains information necessary to ensure compliance with the New Zealand Electrical Code of Practice for Installation and Maintenance of Recessed Luminaires and Associated Equipment AS/NZS 60598.2.2:2001
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>