HALCYON R692 W3KFR LED Recessed Luminaire Owner’s Manual
- June 10, 2024
- HALCYON
Table of Contents
HALCYON R692 W3KFR LED Recessed Luminaire Owner's Manual
Recessed luminaire has been tested in NZ in accordance with building materials and structures test standard AS 1530.4:2014 and has achieved a 60 minute fire resistance pass result if this luminaire is installed in a building with materials and structures the same as (or superior to) those described in test report. Refer to BRANZ technical opinion document on following page for clearance and installation requirements into GIB® fire rated floor/ceiling systems.
Fire Test Report Number: FP13616-001 Issue 1 Issue Date: 9 April 2021
In the vicinity of the recessed luminaire, use an insulation product that:
(a) Maintains its dimensions and structural integrity when exposed to a
temperature of 90°C; and
(b) Withstands a 30-second needle flame test carried out in accordance with
AS/NZS 60695.11.5 with the flame applied to all surfaces of the sample.
This data sheet contains information necessary to ensure compliance with the
New Zealand Electrical Code of Practice for Installation and Maintenance of
Recessed Luminaires and
Associated Equipment AS/NZS 60598.2.2:2001
Cut out 82mm
- Switch off mains power supply
- Connect Dimmable Driver to mains voltage cable (L, N) Do not connect downlight to driver if driver is live. Inrush current from live driver will cause instant downlight failure. Do not switch secondary side.
- Carefully install downlight into Pre-cut 82mm hole.
- Turn on mains power and switch on lighting circuit.
Cutting of holes prior to receiving goods is entirely at the risk of the
installer.
10 Basalt Place, East Tamaki, Auckland, PO Box 58-501, Botany, Manukau 2163,
Auckland, New Zealand
Ph (0064 9) 273-9177
Fax (0064 9) 273 9155
Email: [email protected]
Web: www.halcyonlights.co.nz