HALCYON EX912 B34 2.5W Low Glare Wall Eyelid Select Luminaire Instruction Manual

June 10, 2024
HALCYON

EX912 B34 2.5W Low Glare Wall Eyelid Select Luminaire
Instruction ManualHALCYON EX912 B34 2.5W Low Glare Wall Eyelid Select
Luminaire

EX912 B34 2.5W Low Glare Wall Eyelid Select Luminaire

EX912 B34
This luminaire must be installed by a qualified Registered Electrician to prevent damage to the luminaire and maintain electrical safety.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Base plate,cable entry gland and screw heads must be covered in silicon sealant. Failure to do so may cause luminaire failure from water ingress.
All exterior luminaires (with the exception of copper) require periodic cleaning to protect the surface and/or coating from corrosion and ensure tidy appearance for the  lifespan of the product. Wash with care using a soft brush and warm soapy water using a neutral detergent. Coastal areas require extra attention, especially fittings which are under eaves/soffits and do not have any exposure to rain. Do not use a water blaster or high pressure hose, do not submerge fittings for extended periods of time. 316  stainless steel fittings will still develop surface rust or “tea staining” if left uncared for.

HALCYON EX912 B34 2.5W Low Glare Wall Eyelid Select Luminaire - parts
1HALCYON EX912 B34 2.5W Low
Glare Wall Eyelid Select Luminaire - parts 2

Note: In order to reach the required IP, the input cable for the luminaries must be H05RN-F 3×1.0mm², and threading through before stripping.HALCYON EX912 B34 2.5W Low Glare Wall Eyelid Select Luminaire -
parts 3

Note: Please keep the cable outlet in the same vertical direction with the inlet to luminaries

FIG-3-B
Wood board
Please make sure the thickness of the wood board no less than 10mm

Note: Please keep the cable outle in the same vertical direction with the inlet to luminaries.

HALCYON EX912 B34 2.5W Low Glare Wall Eyelid Select Luminaire - parts
5HALCYON EX912 B34 2.5W Low
Glare Wall Eyelid Select Luminaire - parts 6

Before installing front face, please make sure the earth wire is placed between the driver and terminal block.HALCYON EX912 B34 2.5W Low Glare Wall
Eyelid Select Luminaire - parts 7

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

HALCYON User Manuals

Related Manuals