HALCYON LT7 Ultra Narrow HD Special Series 7W LED Tape Installation Guide
- June 10, 2024
- HALCYON
Table of Contents
LT7 Ultra Narrow HD
Special Series 7W
4mm CRI 90+ HD LED Tape ****
LT7 Ultra Narrow HD Special Series 7W LED Tape
Ultra Narrow (4mm wide) for use in extra tight or extra narrow installations.
High diode density [ 120 diodes per/m ] for flawless appearance and minimal
spotting in shallow
profile extrusion. High CRI for accurate colour rendering and bold saturated
colours. Custom Halcyon diode binning for extremely uniform light appearance
and job consistency.
TECHNICAL
| INPUT VOLTAGE | 24V DC |
|---|---|
| WATTAGE | 7W per/m |
| CURRENT DRAW | 0.29A per/m |
| CRI | CRI 90+ [ R9 <86 ] |
| LIFESPAN | 50,000 hours (L70) |
| BEAM ANGLE | 120° |
| DRIVER | Not included, specify |
according to wattage/current
AVAILABLE IN| Standard IP20:
3000K Warm White or
4000K Natural White
APPLICATION| Interior linear lighting
WARRANTY| 5 Year Warranty
DIMENSIONS
Cut Increments
50mm
Please Note:
Always calculate cut lengths according to minimum cut increments of LED tape.
Tape Width
Standard: 4mm| Tape Height
Standard: 1.4mm
---|---
Recommended Run Lengths
Single feed max run: 10m
10m+: Split into increments with invisible joins and use multiple drivers /
repeaters for unlimited run lengths.
**Note:** 10m length with a single feed will have slight voltage drop at
the end of the tape. Best practice for long runs is to configure the circuit
with dual feeds for reduced voltage drop if possible.
STANDARD (IP20)
| CODE | COLOUR TEMP | LUMENS | DESCRIPTION |
|---|---|---|---|
| LT7 3KUN | 3000K Warm White | 600lm per/m | 7W Ultra Narrow LED tape (specify |
length when ordering)
LT7 4KUN| 4000K Natural White| 640lm per/m| 7W Ultra Narrow LED tape (specify
length when ordering)
ACCESSORIES STANDARD
| CODE | DESCRIPTION |
|---|---|
| LT F | Standard red/black feed cable (pre-soldered) Specify length when |
ordering.
LTFCL| Pendant “Clear” Feed cable (pre-soldered).
Specify length when ordering.
LTJ| Factory join pre-soldered. Specify length when ordering.
INSTALLATION NOTES
- Always check LED Tape wattage and current draw is well within the driver parameters, if in doubt increase driver size. Allow for a minimum of 20% headroom e.g. if you have 19W of LED tape, use a 40W driver, not a 20W.
- LT7 is supplied complete with 3M Adhesive backing.
- Our LED tape is tested and QC checked prior to delivery, custom cut lengths are non returnable.
- LED tape is fragile, take care during transport and installation. Bending or shaping beyond format supplied is to be avoided at all times. 90 degree bends will damage tape and cause failure.
COMPATIBLE PROFILE EXAMPLES
See separate Surface Mount and Recessed profile specification sheets for our complete range of Aluminium Profiles.
XS0809
Ultra Narrow
Surface Mount or
Recess installation for an ultra-narrow modern look.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>